26ENGLISH
◗Never clean, remove or replace shaving unit while motor is on.
◗Do not apply pressure to shaving head combs. Do not touch razor heads with hard objects as this may dent or damage
◗Do not use razor if shaving head combs are damaged or broken. Facial injury may occur.
◗Do not use abrasives, scourers or aggresive liquids such as gasoline or acetone to clean the razor or Jet Clean System.
Cleaning the Shaving Unit
The razor heads may be quickly cleaned after each use by rinsing with hot water.Water from the tap should be on a hot setting, BUT BE CAREFUL TO TEST WATER FIRST SO AS NOT TO BURN OR SCALD HANDS.
◗Regular cleaning guarantees better shaving results.
◗While rinsing razor heads, water may drip out of the base of razor.This is a normal occurrence.
1Always turn razor OFF, remove from charging stand/Jet Clean System before cleaning.
C F | C 2 | Rinse the shaving unit by running under |
|
| hot water for a few minutes. |
ENGLISH 27
| C 3 | Using your thumb and forefinger, grasp the |
|
| sides of the shaving head near the center |
|
| of the shaving unit and pull each individual |
|
| shaving head open. |
C F | C 4 | Rinse all three shaving heads and three |
| ||
|
| hair chambers under hot tap water by |
|
| letting the water run in and around all the |
|
| openings for at least 30 seconds. |
BE CAREFUL TO TEST WATER FIRST SO AS
NOT TO BURN OR SCALD HANDS.
5You can also brush the shaving heads and hair chambers with the brush supplied.
6Carefully shake off excess water and leave the shaving heads open to dry the shaving unit completely.
NOTE: Do not wipe or dry the shaving unit with a towel or tissue.This could damage the shaving heads.
C 7 | Press each shaving head back onto the |
| shaving unit. You will hear a ‘click’. |