Philips 1250X, 1260X, 1280XCC manual Cleaning the Trimmer, Insert the notch of the shaving unit into

Page 19

36ENGLISH

2C 12 Insert the notch of the shaving unit into

 

the slot in the top of the razor (1).Then

 

press the shaving unit down (2) to attach it

1

to the razor.You will hear a ‘click’.

Cleaning the Trimmer

Clean the trimmer after each use.

1Press the trimmer slide forward to slide out the trimmer.

C F

C 2

Rinse the trimmer under hot water. BUT

 

 

BE CAREFUL TO TEST WATER FIRST SO

 

 

AS NOT TO BURN OR SCALD HANDS.

 

3

Allow trimmer to air dry.

Tip: For optional trimmer performance, lubricate the trimmer teeth with one drop of mineral oil every 6 months.

Cleaning the Jet Clean Canister (1280XCC and 1250XCC)

For optimal performance of the Jet Clean System, it is recommended that you empty the cleaning solution canister and thoroughly rinse the canister clean every 2 weeks.

1Place the Jet Clean System on a flat, level surface.

ENGLISH 37

C 2 Simultaneously press the buttons located on both sides of the Jet Clean System

(1) and lift the appliance off the Jet Clean canister (2).

Always remove appliance from canister by lifting straight up. Do not tilt Jet Clean System.

C3 Discard any remaining cleaning solution in

the canister.

The cleaning solution can be safely poured down the sink as there are no harmful ingredients.

C 4 Simply rinse the canister with warm water. Wipe the canister with a towel or tissue to remove excess water.

C 5 Pour the Jet Clean Solution into the canister up to a level between the two lines located inside the canister.

C 6 Carefully lower the Jet Clean System over the canister making sure the release buttons snap back into position.

Image 19
Contents 1290X 1280X 1280XCC 1260X 1250X 1250XCC 1290X/1280X/1280XCC/1260X/1250X/1250XCC Important Safety Instructions Table of Contents Full 2-Year Warranty Day Money-Back Guarantee FeaturesQuick Charge Razor Holder Cleaning Indicator Light Drying Jet Clean SystemButton Cleaning Program Selector Display provides the following information Full Charge IndicatorCharging Indicator Multi-Level DisplayPower-saving mode 1290X only Blocked Shaving Heads IndicatorLow Battery Indicator Replacement Shaving Unit IndicatorTravel Lock 1280X, 1280XCC, 1260X, 1250X and 1250XCC Power plug transforms 100-240V AC to less than 24V DCCharge Meter Before First UseDisplay on the razor will indicate razor is charging Charging Razor with Jet Clean System 1280XCC and 1250XCCConfiguration for the power outlet Charging in the Charging StandPut It To The Test & Shaving Tips How To Shave With An Electric RazorRecharging Quick ChargeTrimming ShavingTo Groom Sideburns and Moustache Deactivating the travel lock CleaningTravel Lock 1280X, 1280XCC, 1260X, 1250X and 1250XCC Activating the travel lockHair chambers under hot tap water by Cleaning the Shaving UnitHot water for a few minutes Shaving head openPlace the Jet Clean System on a flat, level surface Press the ON/OFF button to start the cleaning cycle Jet Cleaning the RazorPull the razor forward and lift razor from Jet Clean System Extra-thorough cleaning method 12 Insert the notch of the shaving unit into Cleaning the TrimmerLift the appliance off the Jet Clean canister Discard any remaining cleaning solution CanisterStorage Replacement Razor Head Assembly IndicationMaintenance Replacing the Shaving UnitInformation is available 24 hours a day, 7 days a week Battery RemovalAccessories AssistanceFull Twoyear Warranty