Philips 1180X, 1150X manual Cleaning the Shaving Unit in the Jet Clean System 1160XCC

Page 14

26ENGLISH

Cleaning the Shaving Unit in the Jet

Clean System (1160XCC)

CAUTION: Keep cleaning solution out of reach of children. Do not take internally. Avoid contact with eyes. In case of eye contact, thoroughly flush with cold water. If irritation persists, get medical attention.

Important

Only use this razor, charging stand, Jet Clean System and HQ200 cleaning solution provided to charge or clean razor.

Other Philips Norelco razors DO NOT work with this Jet Clean System.

Empty the cleaning solution canister and thoroughly rinse the canister clean with warm water every 2 weeks.

The Jet Clean System thoroughly cleans but does not disinfect your razor, therefore, do not share razor with others.

The charging plug converts 100-240V AC to less than 24V DC.

Place the Jet Clean System on a flat, stable and fluid-resistant surface to avoid any leakage. Be careful not to tip or move the Jet Clean System if it is filled with the cleaning solution.

To avoid evaporation, do not expose cleaning solution to direct sunlight.

Remove the protective razor head cap from the razor before charging or cleaning the razor in the Jet Clean System.

Use this appliance for its intended household use as described in this manual.

ENGLISH 27

1Place the Jet Clean System on a flat, level surface.

C 2 Simultaneously press the buttons located on both sides of the Jet Clean System (1) and lift the appliance off the Jet Clean canister (2).

Always remove appliance from canister by lifting straight up. Do not tilt Jet Clean System.

3Unscrew the lid on the Jet Clean Solution bottle (Model HQ200) provided with the razor. Remove the airtight seal by lifting up the tabs on the seal.

C4 Pour the Jet Clean Solution into the canister

up to a level between the two lines located inside the canister.

NOTE: ONLY USE PHILIPS NORELCO JET

CLEAN SOLUTION (MODEL HQ200) WITH

THE JET CLEAN SYSTEM. ANY OTHER

SOLUTION MAY CAUSE DAMAGE TO YOUR

RAZOR.

C When the cleaning solution level drops below the minimum level, the ‘cleaning chamber empty’ symbol will blink and the razor holder will move to the starting position.

If you clean your razor every day, you should clean and refill the canister approximately every 15 days.

Image 14
Contents 1180X 1160X 1160XCC 1150X 1180X/1160X/1160XCC/1150X Important Safety Instructions Table of Contents Features Razor Holder Jet Clean SystemButton Removable Cleaning Solution Canister LowMulti-Level Display Display provides the following informationBefore First Use Remaining Battery Capacity ModelPower plug transforms 100-240V AC to less than 24V DC Charge MeterCharging in the Charging Stand Charging Razor with Jet Clean System 1160XCCCharging Quick Charge How To Shave With An Electric RazorRecharging Put It To The Test & Shaving TipsTrimming Press the on/off button once to switch on the razorShaving To Groom Sideburns and MoustacheDeactivating the travel lock Travel LockActivating the travel lock Bottom of the shaving unit CleaningCleaning the Shaving Unit Supplied brushCleaning the Shaving Unit in the Jet Clean System 1160XCC Place the Jet Clean System on a flat, level surfaceJet Cleaning the Razor Extra-thorough cleaning method Place the retaining frame back onto the shaving head holder Cleaning the TrimmerLift the retaining frame out of the shaving head holder Discard any remaining cleaning solution in the canister Cleaning the Jet Clean Canister 1160XCCMaintenance Replacing the Shaving UnitAssistance Battery RemovalStorage Accessories Full Twoyear Warranty