English
-1 green LED:
-1 flashing yellow LED: less than 25%
Note: If the battery charge of your Sonicare is low, you hear 3 beeps and 1 LED on the recharge gauge flashes yellow for 30 seconds after the
Note:To keep the battery fully charged at all times, you may keep your Sonicare on the charger when not in use. It takes at least 24 hours to fully charge the battery.
Using your Sonicare
Brushing instructions
1Wet the bristles and apply a small amount of toothpaste.
1
2
4 3 
2Place the toothbrush bristles against the teeth at a slight angle towards the gumline.
3Press the power on/off button to turn on the Sonicare.
4Apply light pressure to maximize Sonicare’s effectiveness and let the Sonicare toothbrush do the brushing for you.
5Gently move the brush head slowly across the teeth in a small back and forth motion so the longer bristles reach between your teeth. Continue this motion throughout your brushing cycle.
Note:To make sure you brush evenly throughout the mouth, divide your mouth into 4 sections using the Quadpacer feature (see chapter ‘Features’).
6Begin brushing in section 1 (outside top teeth) and brush for 30 seconds before moving to section 2 (inside top teeth). Continue brushing in section 3 (outside bottom teeth) and brush for 30 seconds before moving to section 4 (inside bottom teeth).
7After you have completed the brushing cycle, you can
spend additional time brushing the chewing surfaces of your teeth
and areas where staining occurs.You may also brush your tongue, with the toothbrush turned on or off, as you prefer.
Your Sonicare is safe to use on:
-Braces (brush heads wear out sooner when used on braces)
-Dental restorations (fillings, crowns, veneers)
-Periodontal pockets
Personalizing your brushing experience
Sonicare automatically starts in the default Clean mode.To personalize your brushing:
1Prior to turning on the Sonicare, press the Personalized Brushing button to toggle between modes and routines.
,The green LED indicates selected mode or routine.
Note:When the toothbrush is turned on, you can switch between modes but not between routines. Routines should be selected prior to brushing.