SET-UP of Multiple Units | La Crosse Technology WT-62U guide

C.RESETTING THE MIMIMUM AND MAXIMUM RECORDS

1.All the indoor records (minimum and maximum) will be reset after the “IN” button is pressed and held for 5 seconds.

2.All the outdoor records (minimum and maximum) will be reset after the “OUT” button is pressed and held for 5 seconds.

IV. ADDING OUTDOOR REMOTE CONTROL SENDERS (OPTIONAL)

The WS-9013U is able to receive signals from 3 different remote temperature sensors. The remote temperature sensor model(s) that you choose will come with their own set of instructions. Follow these instructions for a complete guide to setting up. Following are some brief instructions for the basic set-up of remote temperature sensor units with the WS-9013U. These extra remote temperature sensors can be purchased through the same dealer as this unit, or by contacting La Crosse Technology directly. A TX6U will monitor temperature only, a TX3U will monitor temperature and display the temperature on its LCD, and the TX3UP will monitor the temperature via a probe for measuring soil or water temperatures..

Note: When setting up multiple units it is important to remove the batteries from all existing units in operation. Then insert batteries into all the remote temperature sensor units in numeric sequence. Second, install batteries into the indoor weather station. Transmission problems will arise if this is not done correctly and if the total time for set-up exceeds 6 minutes.

A. SET-UP OF MULTIPLE UNITS

1.It is necessary to remove the batteries from all units currently in operation.

2.Remove the battery covers to all remote temperature sensor units.