La Crosse Technology WT-62U specifications Indoor Weather Station

Page 9

DETAILED SET-UP GUIDE

I. BATTERY INSTALLATION

A. REMOTE TEMPERATURE SENSOR

1.Remove the mounting bracket. The bracket snaps on and off easily.

2.Remove the battery cover, by sliding the cover down.

3.Observing the correct polarity install 2 AA batteries. The batteries will fit tightly (to avoid start-up problems make sure they do not spring free).

4.Replace the battery cover by sliding upwards. Be sure battery cover is on securely.

B. INDOOR WEATHER STATION

1.Remove the battery cover. To do this, insert a solid object in the space provided at the lower- central position of the battery cover, then push up and pull out on the battery cover.

2.Observe the correct polarity, and install 2 AA batteries.

3.Replace the battery cover.

Battery Cover

Note: Immediately after the batteries

have been installed, each LCD (Liquid Crystal Display) will flash. Within a few seconds the indoor temperature will be displayed. If not, then remove the batteries for 10 seconds and reinstall. If the outdoor temperature is not displayed within four minutes, remove batteries from both units, wait 10 seconds, and reinstall. The time will show -:-- and start searching for the WWVB signal. If it successfully receives the time signal (usually at night), it will display the correct time (default is Eastern).

6

Page 8 Page 10
Image 9
Page 8 Page 10
Contents WT-62U Digital Window Thermometer Installation Warranty Information WS-9013U Wireless 433 MHz Radio-controlled Weather Station Contents Inventory of Contents About Wwvb Radio Controlled Time Do not Press ANY Buttons for 15 Minutes Quick SET-UP GuideIndoor Weather Station Programming Sequence Program ModeII or 24 Hour Time Setting III. Time Zone SettingII. Function Keys GMT IV. Daylight Saving Time DST SettingTime Manual Time SettingVI. Setting the DAY, DATE, and Year VII. Selecting F or C VIII. Setting the LCD Contrast Features of the WS-9013U Indoor TemperatureII. Outdoor Temperature III. Minimum and Maximum Temperature Records Viewing the Indoor Temperature RecordsViewing the Outdoor Temperature Records Resetting the Mimimum and Maximum Records IV. Adding Outdoor Remote Control Senders OptionalSET-UP of Multiple Units Outdoor LCD Mounting Remote Temperature Sensor Mounting with ScrewsMounting with Adhesive Tape II. the Indoor Temperature Station Using the Table StandWall Mounting Maintenance and Care Instructions TroubleshootingTemperature measuring range SpecificationsWarranty Information FCC ID OMO-01RX receiver, OMO-01TX sensor
Top Page Image Contents