La Crosse Technology WT-62U II. the Indoor Temperature Station, Using the Table Stand

Page 22

ensure a secure hold. The mounting surface should be smooth and flat.

2)Remove the protective strip from one side of the tape. Adhere the tape to the designated area on the back of the mounting bracket.

3)Remove the protective strip from the other side of the tape. Position the remote temperature sensor in the desired location, ensuring that the indoor temperature station can receive the signal.

II.THE INDOOR TEMPERATURE STATION

The indoor temperature station can be mounted in two ways:

with the table stand or

on the wall with the use of a wall hanging screw (not included).

A. USING THE TABLE STAND

1)The indoor temperature station comes with the table stand already mounted. If you wish to use the table- stand all that is required is to place the indoor temperature station in an appropriate location.

B. WALL MOUNTING

1)Remove the table stand. To do this, pull down on the stand from the rear and rotate forward.

2)Fix a screw (not included) into the desired wall leaving approximately 3/16 of an inch (5mm) extended from the wall.

3)Place the indoor temperature station onto the screw using the hanging hole on the backside. Gently pull the station down to lock the screw into place.

19

Image 22
Contents WT-62U Digital Window Thermometer Installation Warranty Information WS-9013U Wireless 433 MHz Radio-controlled Weather Station Contents Inventory of Contents About Wwvb Radio Controlled Time Quick SET-UP Guide Do not Press ANY Buttons for 15 MinutesIndoor Weather Station Program Mode Programming SequenceIII. Time Zone Setting II or 24 Hour Time SettingII. Function Keys IV. Daylight Saving Time DST Setting GMTManual Time Setting TimeVI. Setting the DAY, DATE, and Year VII. Selecting F or C VIII. Setting the LCD Contrast Indoor Temperature Features of the WS-9013UII. Outdoor Temperature Viewing the Indoor Temperature Records III. Minimum and Maximum Temperature RecordsViewing the Outdoor Temperature Records IV. Adding Outdoor Remote Control Senders Optional Resetting the Mimimum and Maximum RecordsSET-UP of Multiple Units Outdoor LCD Mounting with Screws Mounting Remote Temperature SensorMounting with Adhesive Tape Using the Table Stand II. the Indoor Temperature StationWall Mounting Troubleshooting Maintenance and Care InstructionsSpecifications Temperature measuring rangeWarranty Information FCC ID OMO-01RX receiver, OMO-01TX sensor