La Crosse Technology WT-62U Mounting Remote Temperature Sensor, Mounting with Screws

MOUNTING

Note: Before permanently mounting ensure that the indoor weather station is able to receive WWVB signals from the desired location. Also, extreme and sudden changes in temperature will decrease the accuracy of the indoor weather station. To achieve a true temperature reading, avoid mounting where direct sunlight can reach the remote temperature sensor. We recommend that you mount the remote temperature sensor on a North- facing wall. The sending range is 80ft—obstacles such as walls, concrete and large metal objects can reduce the range. Place both units in their desired location and wait approximately 15 minutes before permanently mounting to ensure that there is proper reception. The indoor weather station should display a temperature in the OUTDOOR LCD within 4 minutes of setting up.

I. THE REMOTE TEMPERATURE SENSOR

The remote temperature sensor can be mounted in two ways:

•with the use of screws, or

•using the adhesive tape.

A. MOUNTING WITH SCREWS

1)Remove the mounting bracket from the remote temperature sensor.

2)Place the mounting bracket over the desired location. Through the three screw holes of the bracket, mark the mounting surface with a pencil.

3)Where marked, start the screw holes into mounting surface.

4)Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the bracket.

B. MOUNTING WITH ADHESIVE TAPE

1)With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to

18