Omega Vehicle Security CL3512A manual Input Selections, Selector Switch, Adjust

Page 8

// Input Selections

The input selection indicates which input is selected; T1 thermocouple, T2 thermocouple or the difference between the two thermocouples (T1-T2).When the thermometer is turned on, it is set to the temperature input that was in use when the thermometer was last turned off.

Selector Switch

The circular selector switch is used to turn the unit off (!) or to select Reading Mode (Input) or Simulation Mode (Output). There are nine selector switch positions under output which provide rough adjustment of the simulated output.

Adjust

Course and fine adjustment Dials are used in Simulation Mode to allow a particular simulated temperature to be selected once the output has been adjusted close to the desired temperature using the selector switch.

5

Image 8
Contents CL3512A Digital Thermometer & Calibrator Omega.comTM Table of contents Safety Information IntroductionUnpacking Operation Proceedure Drawing of UnitDescriptions of Buttons and Switches Button Hold ModeButtons ButtonInput Selections Selector SwitchAdjust Read Mode Proceedure Source Mode Procedure Calibration Simulation Source Mode Diagram Operator Maintenance Battery ReplacementSpecifications ElectricalGeneral CL3152A Calibration Procedure Input Funtion CalibrationSimulated Output Test CL3512A Calibration Procedures Warranty / Disclaimer OMEGA...Of Course