Omega Vehicle Security CL3512A manual Read Mode Proceedure

Page 9

2.3 Read Mode Proceedure

1.Plug Thermocouple Sensor into input T1 and/or T2.

2.Turn selector switch to Input.

3.Select proper thermocouple type (J, K, T or E) using type button.

4.Press T1 button to read thermocouple connected to input T1. Press T2 button to read thermocouple connected to input T2. Press T1-T2 if difference between T1 and T2 is to be read.

5.To Hold reading press HOLD button. To resume making measurements press HOLD again.

Note: Unit will display -OL if input is out of range or thermocouple is broken or not connected to proper input.

To save battery life, CL3512A will turn off automatically if no is key is pressed for 70 minutes.

6

Image 9 Omega Vehicle Security CL3512A manual Read Mode Proceedure
Contents CL3512A Digital Thermometer & Calibrator Omega.comTM Table of contents Introduction Safety InformationUnpacking Drawing of Unit Operation ProceedureButton Hold Mode Descriptions of Buttons and SwitchesButtons ButtonSelector Switch AdjustInput Selections Read Mode Proceedure Source Mode Procedure Calibration Simulation Source Mode Diagram Battery Replacement Operator MaintenanceElectrical SpecificationsGeneral Input Funtion Calibration CL3152A Calibration ProcedureSimulated Output Test CL3512A Calibration Procedures Warranty / Disclaimer OMEGA...Of Course