D. INSTALL SHOWER ROD
The shower rod, if used, should now be installed. Position the shower rod so the shower curtain hangs inside the bath.
E. SHOWER DOOR INSTALLATION
Shower doors for this unit are available from the Kohler Co. Contact your dealer for more information on shower door availability and installation.
When shower doors are to be installed on this bath module, follow these instructions:
1.Make sure the shower door is the correct size at width, height, header, and threshold.
2.Mark the locations of the fastener holes on the bath module columns.
3.Carefully drill the holes into the bath module columns.
4.To fasten the shower door columns to the bath module columns, install hollow wall anchors that have a 1/8º ± 3/8º wall thickness allowance. Do not overtighten the hollow wall anchors, or damage to the bath module may result.
12. CLEAN-UP AFTER INSTALLATION
When cleaning up after installation, do not use abrasive cleansers as they may scratch and dull the bath surface. Use warm water and a liquid detergent to clean the surface.
Stubborn stains, paint, or tar can be removed with turpentine or paint thinner. Do not allow cleaners containing petroleum distillates to remain in contact with whirlpool surfaces for long periods of time. Plaster can be removed by scraping with a wood edge. Do not use metal scrapers, wire brushes, or other metal tools. A
13.CONFIRM PROPER OPERATION
A.START-UP WHIRLPOOL
Refer to Important Safety Instructions on Page 2.
Please perform the following so the owner can safely receive the benefits of whirlpool bathing.
1.Rotate the jets so they are facing down toward the basin.
2.Fill the whirlpool to a water level at least 2º above the top of the highest jet.
Water temperature in the bath should not exceed 104_F (40_C).
Water Line
Bath | 2º Minimum | |
Wall | ||
| ||
| Jet Trim |
14 | Kohler Co., Kohler, WI |