2.PRODUCT NOTICES
A.INSTALLER HAZARD NOTIFICATION
DANGER: Risk of fire, electric shock, or injury to persons. Read important safety instructions on inside front cover of these instructions.
WARNING: Risk of electrical shock. A licensed electrician should make all electrical connections.
WARNING: Risk of electrical shock. Connect only to a circuit protected by a
WARNING: Risk of electrical shock. Disconnect
power before servicing.
WARNING: Risk of injury or property damage. Please read all instructions thoroughly before beginning installation, including the following Product Requirements.
NOTICE: Follow all local plumbing and electrical codes.
B. FACTORY-ASSEMBLED FEATURES
Factory installed components include pump with integral heater, control, and switch. No installation is needed.
The whirlpool pump and piping are
WARNING: Unauthorized modification may cause unsafe operation and poor performance of the whirlpool. Do not relocate the whirlpool pump, or make other modifications to the whirlpool system, as this could adversely affect the performance and safe operation of the whirlpool. Kohler Co. shall not be liable under its warranty or otherwise for personal injury or damage caused by any such unauthorized modification.
3.PRODUCT REQUIREMENTS
A.SUMMARY OF KEY REQUIREMENTS
SInstall unit to a level subfloor.
SProvide properly dimensioned framing.
SRecess installation is recommended.
B. PLUMBING SPECIFICATIONS
Confirm adequate mounting and connection space of the faucet specified for your installation.
Confirm adequate support for the faucet; large faucets that may be inadvertently used as a means of support are not appropriate or safe for this installation.
In locations where plumbing is adjacent to a masonry wall, make provisions for access to the connections. Construct a separate wall a minimum of 6º from the masonry wall. Install furring when the back of the unit is against the masonry wall.
Because this is a
C. PRODUCT INSPECTION | D. CONNECTIONS AND SERVICE ACCESS |
Carefully unpack the whirlpool, remove the protective tape, and and inspect the unit for damage. Leave all materials in the carton during construction to prevent damage.
NOTICE: Make sure both union connections to the pump are securely tightened.
Before installation, ensure proper access to the final connections.
NOTICE: Provide unrestricted service access to the pump. An access panel must be constructed to allow for sufficient clearance for servicing the pump or controls. The access panel must be located at the pump end of the whirlpool.
Kohler Co., Kohler, WI | 5 |