Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few minutes to review this manual before you start installation. If you encounter any installation or performance problems, please don't hesitate to contact us. Our phone numbers and website are listed on the back cover. Thanks again for choosing Kohler Company.

Recommended Tools and Materials

Pipe	Adjustable	Strap	Hacksaw or
	Wrench	Wrench
Wrench
			Tube Cutter

Assorted	Plumbers	Thread		Propane
	Putty	Sealant	Solder	Torch
Screwdrivers

Introduction

Please read these instructions carefully to familiarize yourself with the required tools, materials, and installation sequences. Follow the sections that pertain to your particular installation. This will help you avoid costly mistakes. In addition to proper installation, read all operating and safety instructions.

All information in this manual is based upon the latest product information available at the time of publication. At Kohler, we constantly strive to improve the quality of our products; we therefore reserve the right to make changes in product characteristics, packaging, or availability at any time without notice.

Before You Begin

This product is designed for drop-in island installation. Undermount and alcove installations are also possible.

You must install the bath onto an adequately supported, level sub¯oor.

Provide properly dimensioned framing.

Choose a ®ll spout which will provide adequate reach and a minimum 2º (5.1cm) air gap above the bathing well rim of the unit. You may need to build up the deck material to obtain adequate air space because the outer rim may be lower than the bathing well rim depending on the speci®c area of the bath.

Follow local plumbing codes.

The unit must be ®lled with water through the bathing well, not the over¯ow channel.

If you plan to install a deck-mounted, hand-held shower, the diverter vacuum breaker must maintain a minimum 1º (2.5cm) air gap above the outer rim.

When using the K-922 or K-923 Laminar Bath Spout with drip tray K-924, the distance from the ®nished wall to the outside wall of over¯ow channel should not exceed 2º (5.1cm).

1012493-2-A

Kohler Co.