System Control | Chromatherapy Light Control |
("On/Off") |
|
Line 1 (Black) | Junction Box | |
Black | ||
Ground (Green) | ||
| ||
Electrician to | Green | |
| ||
provide suitable |
| |
strain relief |
| |
Line 2 (Black) | Black | |
|
Bonding Lugs Follow Local Codes
8. Make the Electrical Connections
NOTE: The product model number is printed on a label on the pump side of the unit. This label also identi®es the electrical rating of the product.
WARNING: Risk of electrical shock.Make sure the power has been disconnected before performing the following procedures. Refer to IMPORTANT INFORMATION section.
CAUTION: Risk of electrical shock. All services must have a Class A
The over¯owing bath control and system have been prewired at the factory using 220V hardwire. A licensed electrician should make a routine service connection to the junction box located on the control box.
Connect service to the junction box. The junction box contains black and green wires. The grounding conductor must not be connected to any
Follow local electrical codes.
9. Test Run the Bath
Check the Connections and Fill the Unit
NOTE: The system will purge air at
Check all electrical connections, and make sure the electrical power to the unit is turned on.
Make sure union connections to the pump and
Make sure the bathing well and over¯ow channel are clean and free of debris.
Fill the bath as you would a normal bath, 4º (10.2cm) ± 6º (15.2cm) from the top, to allow for water displacement when you enter the bathing well. Water entering the over¯ow channel will ¯ow into the drain.
Test the Control Switch
Press the ″On/Off″ control switch to start the pump/motor and begin the
With the unit running, check all harness (piping) connections for leaks.
Visually observe the effervescence rising to the surface of the water.
Kohler Co. | 9 |