Espree™ Bathtub Series
Electrical Connection 6060 w/Heater
On the 6060 with integral skirt, one junction box has been provided for the pump/motor. The motor is bonded to the junction box at the factory. To access, remove skirt access panel.
A separate 120 VAVAC, 15 AMP dedicated circuit with GFCI protected outlet (commercially available) is required for heater and is to be installed in a junction box. The junction box is to be hard wired.
Follow the bonding instructions below:
XX With a #8 solid copper wire, bond the heater to the house electrical panel or approved local bond. A bonding lug is provided on the heater.
Initial Start-Up
XX Push the GFCI test button. The reset button should pop out.
YY Push this button in to reset. If the interrupter fails to operate in this manner, there is a ground current flowing or a device malfunction, indicating the possibility of electrical shock.
ZZ Turn off power and do not use the bath until the source of the problem has been identified and corrected.
6060 Corner Unit
Bonding
For Heater
For Pump/Motor
GFCI |
| Bonding to | ||||||||
|
|
|
|
|
|
| Pump/Motor | |||
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
English
|
|
|
|
|
|
|
|
J- | Box | Power Cord | |
(Commercially Available) |
|
| |
GFCI | Bonding to |
(Commercially Available) | RapidHeat™ |
Heater ON
Overheat
Protection
Press to Reset
Power Cord | |
(Commercially Available) |
Installation and Operation | www.jacuzzi.com | Page 13 |