English
Espree™ Bathtub Series
Rapdheat™ Operation
Once the heater is installed and the whirlpool pump is operating, the heating function is totally automatic. The heater will help maintain the temperature of the water in the bath. The heater is designed to help maintain the temperature of the bath water once the water is added at the desired temperature level. It does not replace the need to have adequate hot water supply for the filling of the bath.
Vacuum Switch
The heater is equipped with a preset vacuum switch which will not allow the heater to turn ON if the pump is not running with water flowing through the whirlpool system.
High-Limit Switch
The heater includes an exclusive
Overheat Protection
Heater ON
safety circuit will not false trip from hot tap water. It will only turn off the heater, if the thermostat fails. To reset, press the button.
Heater On Indicator
The light will be illuminated any time the heater is operating.
Press to Reset
Whirlpool Control
The whirlpool action in your bath is influenced by three factors – direction of flow, force of water, and force of air. All baths manufactured by Jacuzzi Whirlpool Bath are equipped with fully adjustable PowerPro® jets, which are adjustable for all three factors. Some baths have additional directionally adjustable jets which can be adjusted for direction and flow of air only.
Direction
To change the direction of the water flow, swivel the jet nozzle to the desired angle. The jets can be directed individually toward any location on your body to provide a hydromassage. The jets can also be adjusted so that they all point in the same direction (clockwise or counterclockwise) to circulate the water in a circular motion around the bath, causing a total whirlpool effect.
Water Force
The high volume, fully adjustable jets can be adjusted to control the force of the water coming into the bath. For robust action, increase the force of the flow by rotating the jet handles to the left (counterclockwise). For a more gentle effect, rotate the handles to the right (clockwise).
Never run the whirlpool system with all the jets closed.
Force of Air
Two knobs located on the bath serve as controls for the air induction system. The intensity of the hydromassage whirlpool action is determined by the amount of air inducted into the water. As the amount of air is increased, the hydromassage action increases. For maximum air induction, rotate the control knobs fully counterclockwise to the largest circles. For fewer air bubbles, decrease the amount of air induction by rotating the control knob clockwise. When the knobs are turned to the smallest circles, only water is being circulated.
Air Induction Control Knobs
Large Adjustable Jets
Small Multidirectional Jets
Page 18 | www.jacuzzi.com | Installation and Operation |