Switch and Function Definitions, Switch Definitions

SWITCH AND FUNCTION DEFINITIONS

SWITCH DEFINITIONS

��

			CAL
			TARE
			H1
			H2
MENU	ZERO	CAL	L1
MENU	ZERO	CAL	L2
			L2

S1 S2 S3 S4 S5

Menu Switch (S1)

The Menu switch (S1) is used to cycle through the flow controller setpoints, alarm setpoints, alarm hysteresis, calibration values and decimal point locations.

The sequence is as follows. The designators, in parenthesis, identify text that will be displayed, momentarily, followed by the value.

Setpoint for Flow	(StPt)
Alarm Set Point High 1	(SPH1)
Alarm Set Point Low 1	(SPL1)
Alarm Set Point High 2	(SPH2)
Alarm Set Point Low 2	(SPL2)
Hysteresis High	(HH)
Hysteresis Low	(HL)
Cal	(CAL)
Decimal Point	(dP)
Exit

While in the Mode Selection sequence, the indicator is no longer monitoring the input signal. To exit at any time, simply depress S4. All new data entered prior to exiting, except StPt, will be stored in non-volatile memory and recalled at power on. The StPt value is retained in static RAM and valid only while power to the unit is maintained. At power turn on the value of StPt defaults to 0000 for safety and the Setpoint output voltage will be approximately -0.5 vdc.

Increment Switch (S2)

This switch increments the flashing digit. When first used, no digits may be flashing. The most significant digit for StPt can be turned off using S2. While updating this digit the display will toggle through the following digits: 1, 2, 3, 4, 5, 6, 7, 8, 9, Blank. Zero (0) can not be selected.

Page 5