Graham Field LF1031FP user manual Install push handles Install spreader bar

Page 10

6.Screw the push handles into the mast and tighten the nuts.

7.Insert spreader bar attachment rod into spreader bar. Insert spreader bar rod into the U-bracket at the end of the boom. Align holes. Insert spreader bar attachment bolt and tighten.

8.For shipping purposes, the boom is in its lowest posi- tion. To elevate, turn the pump knob clockwise until hand tight and operate the pump handle.

install push handles

install spreader bar

9.Operate the foot pedal to adjust the base width.

The picture at near right shows the base end op- posite the foot pedal at minimum width; the left food pedal has been com- pletely depressed.

The picture at far right shows the base end op- posite the foot pedal at maximum width; the right foot pedal has been com- pletely depressed.

base at minimum width

elevate boom

base at maximum width

1031FP-INS-LAB-RevA11

10

Image 10
Contents LF1031FP Hydraulic Patient Lift With Foot Pedal Contents Introduction Safety Precautions 1031FP-INS-LAB-RevA11 Features Unpacking Handling ProceduresShipping and Transportation Instructions InspectionAssembly Instructions ComponentsAssembly Install push handles Install spreader bar Lifting the patient from a bed Operating InstructionsLifting the Patient Lowering the patient onto a bedLifting the patient from the floor Lowering the patient to the floorRemoving the sling Before Each USE Care and MaintenanceLubrication Checking for Damage and Wear CleaningCare of Slings Installation of 1010S005 Hydraulic Pump Removal of Existing PumpInstallation of New Pump Maintenance Schedule Troubleshooting Symptom Possible Cause ActionSpecifications Limited Warranty GF Health Products, Inc. Graham-Field Index