Graham Field LF1031FP Installation of 1010S005 Hydraulic Pump, Removal of Existing Pump

Page 16

INSTALLATION OF 1010S005 HYDRAULIC PUMP

Removal of Existing Pump

1.Follow the instructions in this section to remove the existing pump, shown at near right. If installing pump for the first time, proceed to INSTALLATION OF NEW PUMP.

2.Remove the top of the exist- ing pump from the upper boom bracket, as shown at mid-right: Use two 9/16" wrenches to remove the hardware that secures top of pump to upper boom bracket. This will free the pump to rotate downward.

3.Remove the bottom of the exist- ing pump from the lower mast bracket, as shown at far right. Use two 9/16" wrenches to remove the hardware that secures bottom of pump to lower mast bracket. This will free the pump — take care that it does not fall.

existing pump

existing pump

upper boom

boom

bracket

 

detach existing pump from upper boom

lower mast

mast bracket

detach existing pump from lower mast

1031FP-INS-LAB-RevA11

16

Image 16
Contents LF1031FP Hydraulic Patient Lift With Foot Pedal Contents Introduction Safety Precautions 1031FP-INS-LAB-RevA11 Features Handling Procedures Shipping and Transportation InstructionsUnpacking InspectionAssembly Instructions ComponentsAssembly Install push handles Install spreader bar Operating Instructions Lifting the PatientLifting the patient from a bed Lowering the patient onto a bedLifting the patient from the floor Lowering the patient to the floorRemoving the sling Before Each USE Care and MaintenanceLubrication Checking for Damage and Wear CleaningCare of Slings Installation of 1010S005 Hydraulic Pump Removal of Existing PumpInstallation of New Pump Maintenance Schedule Troubleshooting Symptom Possible Cause ActionSpecifications Limited Warranty GF Health Products, Inc. Graham-Field Index