UPHOLSTERY/POSITIONING STRAP | PROCEDURE 5 |
| REPLACING SEAT POSITIONING |
This Procedure Includes the Following: | |
| STRAP (FIGURE 2) |
Replacing Seat Upholstery | |
Replacing Seat Positioning Strap | 1. If necessary, remove the seat cushion from the seat |
| upholstery. |
|
U P
WARNING
After ANY adjustments, repair or service and BE- FORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.
REPLACING SEAT UPHOLSTERY (FIGURE 1)
1.Remove the eight (8) phillips screws and washers that secure the existing seat upholstery to the crossbraces.
2.Removeexistingseatupholsteryfromthecrossbraces.
3.Line up mounting holes in new seat upholstery with mounting holes in the crossbraces.
4.Securelytightenwithexistingphillipsscrewsand wash- ers.
NOTE: Clean upholstery with warm DAMP cloth and mild detergent to remove superficial soil.
WARNING
Laundering or moisture will reduce flame re- tardation of the upholstery.
2.Remove the two (2) rear phillips screws and washers that secure the seat upholstery and seat positioning strap to the crossbraces.
3.Remove the two (2) halves of the seat positioning strap from the crossbraces.
4.Position the two (2) new seat positioning strap halves between the seat upholstery and the crossbraces.
5.Reinstall the rear phillips screws and washers that secure the seat upholstery and seat positioning strap to the crossbraces.
NOTE: Washer is positioned on top of seat upholstery.
6.If necessary, reinstall the seat cushion onto the seat upholstery.
Washer | Rear Phillips Screw | |
Seat Upholstery | ||
|
Seat Positioning
Strap
H O L S T E R Y
P O S I T I O
Phillips Screws
Washers
Crossbrace
FIGURE 2 - REPLACING SEAT POSITIONING STRAP
N
I
N
G
S T R A P
Seat Upholstery
FIGURE 1 - REPLACING SEAT UPHOLSTERY
19