GE 27944 manual Connecting the AC Electrical Power, Connecting the Telephone Line, Wall Mounting

CAUTION: To reduce the risk of fire or personal injury, use only the ATLINKS, Inc. Nickel-Cadmium battery model 5-2548 that is compatible with this unit.

2.Locate the battery compartment on the back of the handset.

3.Plug the battery pack cord into the jack inside the compartment.

NOTE: It is important to maintain the polarity (black and red wires) to the jack inside the compartment. To ensure proper battery installation, the connector is keyed and can be inserted only one way.

BATTERY

RED WIRE

PRESS DOWN
FIRMLY	BLACK WIRE

4.Insert the battery pack.

5.Close the battery compartment by pushing the door up until it snaps into place.

6.Place the handset in the charging cradle.

CONNECTING THE AC (ELECTRICAL) POWER

Plug the power adaptor cord into the power jack on the bottom of the base and the other end into an electrical outlet.The in use/charge indicator (on the base) turns on to indicate the battery is charging when the handset is on the cradle.

Allow the phone to charge for 16 hours prior to first use. If you don’t properly charge the phone, battery performance is compromised.

CAUTION: Use only the ATLINKS USA, Inc. power adaptor 5-2616 (black) or 5-2617 (gray) power adaptor that came with this unit. Using other power adaptors may damage the unit.

CONNECTING THE TELEPHONE LINE

1.Plug one end of the telephone line cord into the jack on the bottom of the base calledTEL LINE and the other end into your home’s modular phone jack.

2.Set the ringer switch (on the handset) to ON, and place the handset in the cradle on the base.

WALL MOUNTING

If you want to mount the phone on a wall, slip the mounting holes (on the back of the base) over the wall plate posts, and slide the unit down into place. (Wall plate not included.)

8