GE 25880, 00004228 manual Installing the Handset Battery

Page 10

IMPORTANT INSTALLATION GUIDELINES

•Install telephone near both a telephone (modular) jack and an electrical power outlet.

•Avoid sources of noise, such as a window by a busy street, and electrical noise, such as motors, microwave ovens, and fluorescent lighting.

•Avoid heat sources, such as heating air ducts, heating appliances, radiators, and direct sunlight.

•Avoid areas of excessive moisture or extremely low temperature.

•Avoid dusty locations.

•Avoid other cordless telephones or personal computers.

INSTALLING THE HANDSET BATTERY

NOTE: You must connect the handset battery before use.

1.Locate battery and battery door which are packaged together inside a plastic bag and are separate from the handset.

2.Locate the battery compartment on the back of the handset.

3.Plug the battery pack cord into the jack inside the compartment.

NOTE: It is important to maintain the polarity (black and red wires) to the jack inside the compartment. To ensure proper battery installation, the connector is keyed and can be inserted only one way.

BATTERY

RED WIRE

PRESS DOWN
FIRMLY	BLACK WIRE

4.Insert the battery pack.

5.Close the battery compartment by pushing the door up until it snaps into place.

10

Image 10

Contents Page Equipment Approval Information Notification to the Local Telephone CompanyLicensing Interference InformationHearing AID Compatibility HAC Table of Contents Changing the Battery Introduction Page Handset and Charge Cradle Layout Base LayoutImportant Installation Information Before YOU BeginInstalling the Handset Battery Installing the Phone Telephone SET UP Language Rings to Answer You may choose from three different ringer tones Local Area Code Basic Operation When finished, put the handset back on the cradle to hang up Call Timer To quickly redial the last number you dialed This feature helps you locate a misplaced handset Mute Speakerphone Operation Make sure the phone is OFF not in Talk mode Receiving AN Incoming Telephone Call During AN Intercom Call Memory Enter NameStoring a Redial Number Dialing a Stored Number Handset Caller ID CID Transferring CID Records to Memory Dialing a Caller ID Number Deleting the Current Caller ID Record Answering System SET UP Answering System Operation Sample Outgoing AnnouncementScreening Calls from the Base Remote Access When the answering system picks up Base LCD shows Remote Access Answering Call Changing the Battery Headset and Belt Clip Operation Display MessagesDELETE? Handset Sound Signals Troubleshooting GuidePage Caller ID Solutions General Product Care Causes of Poor ReceptionIndex Page Service Accessory InformationLimited Warranty For how long after your purchase

Related manuals

Manual 100 pages 24.17 Kb