GE 00004228, 25880 manual Handset Sound Signals, Troubleshooting Guide

Page 43

ANSWERER REMOTE	Indicates the answering system is being
/ANSWERER REMOTE	accessed remotely.
ACCESS
PAGING/	The page/intercom on base or int/transfer button
PAGING FROM	on cordless handset has been pressed.
HANDSET/
PAGING FRM BASE/
PAGING HANDSET
ENTER NUMBER	Prompt telling you to enter a telephone number
	in one of the 10 memory locations.
HANDSET SOUND SIGNALS
Signal		Meaning
A long warbling tone (with ringer on)		Signals an incoming call
Three short beeps		Page signal
One short beep (every 7 seconds)		Low battery warning

TROUBLESHOOTING GUIDE

TELEPHONE SOLUTIONS

No dial tone

•Check and repeat installation steps:

Ensure the base power cord is connected to a working outlet .

Ensure the telephone line cord is connected to the base and the wall jack .

•Connect another phone to the same jack; if there is still no dial tone, the problem might be your wiring or local service.

•The cordless handset may be out of range of the base. Move closer to the base.

•Ensure the battery is properly charged (16 hours).

•Ensure the battery pack installed correctly.

43

Image 43

Contents Page Notification to the Local Telephone Company Equipment Approval InformationLicensing Interference InformationHearing AID Compatibility HAC Table of Contents Changing the Battery Introduction Page Base Layout Handset and Charge Cradle LayoutBefore YOU Begin Important Installation InformationInstalling the Handset Battery Installing the Phone Telephone SET UP Language Rings to Answer You may choose from three different ringer tones Local Area Code Basic Operation When finished, put the handset back on the cradle to hang up Call Timer To quickly redial the last number you dialed This feature helps you locate a misplaced handset Mute Speakerphone Operation Make sure the phone is OFF not in Talk mode Receiving AN Incoming Telephone Call During AN Intercom Call Enter Name MemoryStoring a Redial Number Dialing a Stored Number Handset Caller ID CID Transferring CID Records to Memory Dialing a Caller ID Number Deleting the Current Caller ID Record Answering System SET UP Sample Outgoing Announcement Answering System OperationScreening Calls from the Base Remote Access When the answering system picks up Base LCD shows Remote Access Answering Call Changing the Battery Display Messages Headset and Belt Clip OperationDELETE? Troubleshooting Guide Handset Sound SignalsPage Caller ID Solutions Causes of Poor Reception General Product CareIndex Page Accessory Information ServiceFor how long after your purchase Limited Warranty

Related manuals

Manual 100 pages 24.17 Kb