Lucent Technologies 555-230-796 manual Installation Procedure

Page 41

Installation

In addition to the back panel connections, a three-color light- emitting diode (LED) is visible through the top of each unit and provides information about the status of the equipment.

Installation Procedure

Installing the Remote Module involves connecting the line cords, the telephone cord, the power cord, and, at your option, the RS-232 cable. The line cord and power cord are supplied with your Remote Module, and the telephone cord and any power cords required for the operation of the telephone are supplied with the display telephone.

Follow these steps to install the Remote Module:

! CAUTION:

Do not plug the A/C adapters into the electrical outlets until instructed to do so in the following procedure.

1.Ensure that the module has the proper DIP switch configuration (see Table 2-1).

2-4Issue 2 July 1997

Image 41

Contents Definity Extender Your Responsibility for Your System’s Security Trademarks Contents Connections for Data Transmission Ii Issue 2 July Using the Telephone for Programming GL-1 Figures Tables TroubleshootingImportant Safety Instructions Viii Issue 2 July Customer Support Information Support Telephone Number Security of Your System Preventing Toll Fraud Lucent Technologies Fraud Intervention Limited Warranty FCC Notification Repair Information Installation and Operational Procedures Customer Support Information Xvi Issue 2 July Intended Audience About This BookSecurity Alert Terms and ConventionsTypographical Conventions How to Use This BookProduct Safety Labels Call Related DocumentsDefinity Enterprise How to Comment on This Document Feedback Form This Form MAY be Photocopied Introduction1 System Configuration System Operation ConfigurationEquipment List Page Compatibility Specifications Remote Module Specifications Considerations Security Alert How to install the Definity Extender Remote Module Installation2Electrical Requirements Location RequirementsRemote Module Back Panel Connecting the Remote ModuleInstallation Procedure DIP Switch Configuration Connections for Data Transmission RS-232 Cable Pin Connections Programming3 Telephone Keys Used in Programming Using the Telephone for ProgrammingSetting the Telephone Number Setting Pulse Dialing Setting the Mode of DialingSetting Tone Dialing Setting the Connect Rate Issue 2 July 1997 Setting the COM Port Baud Rate Exiting Programming Operating the Remote Module of the Definity Extender Operating the Remote ModuleStarting the Operation Connect Sequence for the Remote Module Disconnecting Operating the Remote Module Changing a Password Page Security Alert Checking System Software Page Troubleshooting, LED Activity, and Error Messages Troubleshooting5Troubleshooting LED Sequences Error MessagesOn next Error Messages Dedicated Subscriber Lines GlossaryGL-2Issue 2 July Issue 2 July 1997 GL-3