Lucent Technologies 555-230-796 manual Setting the Connect Rate

Page 50

Programming

Setting the Connect Rate

Setting the Connect Rate establishes the baud rate in kilobits per second (kbps) for the communications between the Switch and Remote Modules. Follow the steps and screens below to set the Connect Rate.

1.At the “Go Online?” screen, press 3 until the following screen appears:

2.Press 2 to change the connect rate. The following screen appears:

3.Press 3 until the Connect Rate you want appears. There are six choices:

■Auto—(Factory default). When the auto setting is selected, the module tries to connect at the speed that will provide the best performance with the fewest errors. The speed will vary depending on line performance. If the module is unable to connect at any of the available speeds, an error message appears.

■F-- —The Remote Module will connect at 19.2 kbps only, the fastest rate.

3-6Issue 2 July 1997

Image 50

Contents Definity Extender Your Responsibility for Your System’s Security Trademarks Contents Connections for Data Transmission Ii Issue 2 July Using the Telephone for Programming GL-1 Figures Troubleshooting TablesImportant Safety Instructions Viii Issue 2 July Customer Support Information Support Telephone Number Security of Your System Preventing Toll Fraud Lucent Technologies Fraud Intervention Limited Warranty FCC Notification Repair Information Installation and Operational Procedures Customer Support Information Xvi Issue 2 July About This Book Intended AudienceTerms and Conventions Security AlertHow to Use This Book Typographical ConventionsProduct Safety Labels Related Documents CallDefinity Enterprise How to Comment on This Document Feedback Form This Form MAY be Photocopied Introduction1 System Operation Configuration System ConfigurationEquipment List Page Compatibility Specifications Remote Module Specifications Considerations Security Alert Installation2 How to install the Definity Extender Remote ModuleLocation Requirements Electrical RequirementsConnecting the Remote Module Remote Module Back PanelInstallation Procedure DIP Switch Configuration Connections for Data Transmission RS-232 Cable Pin Connections Programming3 Using the Telephone for Programming Telephone Keys Used in ProgrammingSetting the Telephone Number Setting the Mode of Dialing Setting Pulse DialingSetting Tone Dialing Setting the Connect Rate Issue 2 July 1997 Setting the COM Port Baud Rate Exiting Programming Operating the Remote Module Operating the Remote Module of the Definity ExtenderStarting the Operation Connect Sequence for the Remote Module Disconnecting Operating the Remote Module Changing a Password Page Security Alert Checking System Software Page Troubleshooting5 Troubleshooting, LED Activity, and Error MessagesTroubleshooting Error Messages LED SequencesOn next Error Messages Glossary Dedicated Subscriber LinesGL-2Issue 2 July Issue 2 July 1997 GL-3