Lucent Technologies 555-230-796 manual Issue 2 July 1997

Page 51

Programming

■FM- —The Remote Module will connect at 19.2 or 16.8 kbps.

■-M- —The Remote Module will connect at 16.8 kbps only.

■-MS —The Remote Module will connect at 16.8 or 14.4 kbps.

■--S —The Remote Module will connect at 14.4 kbps only, the slowest rate.

NOTE:

In some situations, selection of a slower connect rate may result in a more reliable connection. The higher the connect rate you choose, the greater is the possibility of data errors. When a high number of data errors is detected, your call connection may be interrupted while the Remote Module attempts to reconnect. When this happens, you and your caller will hear a beep followed by a message (called the “retrain” prompt):

Please remain on the line. This call is experiencing technical difficulties. Your call will resume momentarily.

After this message, you and your caller will hear a second beep. The call is restored immediately after the second beep.

NOTE:

If the line problems cause the call to completely disconnect, you and your caller will hear the following message:

We are (still) experiencing technical difficulties on this call. We apologize for this inconvenience. If you initiated this call, please hang up and place your call again.

Issue 2 July 1997 3-7

Image 51

Contents Definity Extender Your Responsibility for Your System’s Security Trademarks Contents Connections for Data Transmission Ii Issue 2 July Using the Telephone for Programming GL-1 Figures Tables TroubleshootingImportant Safety Instructions Viii Issue 2 July Customer Support Information Support Telephone Number Security of Your System Preventing Toll Fraud Lucent Technologies Fraud Intervention Limited Warranty FCC Notification Repair Information Installation and Operational Procedures Customer Support Information Xvi Issue 2 July Intended Audience About This BookSecurity Alert Terms and ConventionsTypographical Conventions How to Use This BookProduct Safety Labels Call Related DocumentsDefinity Enterprise How to Comment on This Document Feedback Form This Form MAY be Photocopied Introduction1 System Configuration System Operation ConfigurationEquipment List Page Compatibility Specifications Remote Module Specifications Considerations Security Alert How to install the Definity Extender Remote Module Installation2Electrical Requirements Location RequirementsRemote Module Back Panel Connecting the Remote ModuleInstallation Procedure DIP Switch Configuration Connections for Data Transmission RS-232 Cable Pin Connections Programming3 Telephone Keys Used in Programming Using the Telephone for ProgrammingSetting the Telephone Number Setting Pulse Dialing Setting the Mode of DialingSetting Tone Dialing Setting the Connect Rate Issue 2 July 1997 Setting the COM Port Baud Rate Exiting Programming Operating the Remote Module of the Definity Extender Operating the Remote ModuleStarting the Operation Connect Sequence for the Remote Module Disconnecting Operating the Remote Module Changing a Password Page Security Alert Checking System Software Page Troubleshooting, LED Activity, and Error Messages Troubleshooting5Troubleshooting LED Sequences Error MessagesOn next Error Messages Dedicated Subscriber Lines GlossaryGL-2Issue 2 July Issue 2 July 1997 GL-3