Technicolor - Thomson TG787 manual Connecting Phones to the Thomson Gateway, Emergency calls

3 Adding New Devices to your Network

3.2.1Connecting Phones to the Thomson Gateway

Procedure

Use a phone cable with RJ-11 connectors to:

1Wire the green Thomson Gateway Phone port(s) to your phone(s) or fax.

2If your Thomson Gateway has a black port labelled "PSTN", you must connect this port to the telephone output of your DSL splitter to allow analogue phone calls with the same telephone set that you use for VoIP calls.

This is only required if you still want to make phone calls using the analogue telephone line.

Be aware that, if the PSTN port (if provided) is not wired to your telephone wall outlet or distributed filter, emergency calls are not always possible!

As distributed filters are country-specific, you cannot use the device everywhere.

If this is not the case, no additional connections are needed.

Emergency calls

If the device is not powered, the Thomson Gateway will automatically select the analogue signal (if connected). So you still will be able to make emergency calls.

24 E-DOC-CTC-20080118-0051 v2.0