Technicolor - Thomson TG787 manual Activating services on the web pages, Call Forwarding

4 Getting the Most Out of Your Thomson Gateway

Activating services on the web pages

To activate/deactivate supplementary services via the web page:

1Browse to the Thomson Gateway Web Interface.

2On the Tools menu, click Content Sharing.

3In the Navigation Bar, click Configure.

4In the Pick a task list, click View Telephony Services.

5In the Navigation Bar, click Configure.

6To activate/ deactivate supplementary services select/clear the check box of the supplementary service.

7Click Apply.

Call Forwarding

Call Forwarding informs you about the call forwarding parameters:

CFNR-timeror Call Forwarding on No Reply timer is the time expressed in seconds after which an incoming call is forwarded when not answered.

CFNR-destinationor Call Forwarding on No Reply destination is the telephone number to which a call is forwarded to when the CFNR-timer expires.

CFU-destinationor Call Forwarding Unconditional is the telephone number to which an incoming call is always forwarded to.

CFBS-destinationor Call Forwarding on Busy Subscriber is the telephone number to which an incoming call is forwarded to when your telephone is busy.

Using switching order commands

In order to use switching order commands (R or hook flash followed by a digit), certain supplementary services have to be activated.

The following list gives an overview of the supplementary services that have to be activated in order to use switching order commands (SOC):

Activate Hold when you want to

Action	Press	Illustration
To put an active call on hold and enable a	R, 2	B	C			B		C
call set up (the dial tone is generated)					A presses
		active			R2	on hold
			A					dial tone
							A
To terminate the call on hold	R, 0	B	C			B		C
				A presses
		active	on hold		R0	active

AA

To terminate an active call and switch to	R, 1			B	C
the call on hold	B	C
			A presses
	active	on hold	R1		active

AA

42 E-DOC-CTC-20080118-0051 v2.0