22
GENERAL INFORMATION 23
Caller’s details are not displayed
•Make sure you have subscribed to a Caller ID service via your network provider.
•The caller may have withheld their details.
•Let the phone ring a couple of times as there may be a delay in receiving the Caller ID information.
Accidental key press to the keypad may occur
•Always use manual key lock.
•When answering a call, always keep contact with your ear and the receiver.
•Avoid touching the keypad area when handling.
Caller’s name is not displayed even though it is stored in
I cannot seem to access the answering machine remotely
•Are you entering the correct remote access PIN, default code is 0000.
Electrostatic discharge
If your Touch phone has been subjected to a large electrostatic discharge or a power surge the unit may need to be reset. Use the following procedure to reset the system.
1Remove the batteries from all the cordless handsets
2Unplug the power and the phone line to the main base unit
3Leave it like this for approximately 15 minutes
4Put everything back together and try the handsets again
5If this does not fix the problem call our support line
IMPORTANT
This equipment is not designed for making emergency telephone calls when the power fails. Alternative arrangements should be made for access to emergency services.
SAFETY
•The LCD display is made of glass and may break if the handset is dropped. Place the phone securely on a stable surface.
•Only use the power supply that came with the product. Using an unauthorised power supply will invalidate your guarantee and may damage the telephone.
Battery Usage
IMPORTANT
THERE IS A RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
Never use
Battery requirements: Each handset requires three rechargeable
Batteries
the phonebook
•The name will only be displayed if an exact number match (including STD dialling code) is found.
• Use only the battery type listed in this user guide. Do not |
use Alkaline or lithium batteries. |
• Do not dispose of the batteries in a fire, as they can |
Answeringtouchmachine is not recording messages
• Check that you have set ‘Announce Only’ to Off, see page 13.
• The message memory may be full, try deleting some old messages, see page 11.
Base:
Input: 240 VAC 50 Hz
Output: 8 VDC 500 mA
Polarity: Centre positive
Charger:
Input: 240 VAC 50 Hz
Output: 6 VDC 300 mA
Polarity: Centre positive
explode. |
• Do not open or mutilate the batteries. Released |
electrolyte is corrosive and can cause damage to the eyes |
or skin. It can be toxic if swallowed. |
• Avoid contact with metal objects when handling the |
batteries. These objects could short out the batteries or |
cause the conductor to overheat resulting in burns. |
• Do not attempt to recharge the batteries by heating them. |