Oricom TA2000 Series manual Quick SET UP, Make sure your base is

Page 4

QUICK SET UP

Make sure your base is:

Located within reach of a mains power socket and telephone socket.

At least 1 metre away from other electrical appliances, to avoid interference.

Not located in humid or damp conditions, e.g. in a bathroom.

1 Connect the base power lead and the telephone line cord to the back of the base. Plug the power adaptor into the mains wall socket.

2 For multi-handset packs only: Plug the charger power adaptor into the mains power socket.

3 On each handset: Slide the battery cover off and insert the batteries supplied following the markings shown inside the battery compartment, then slide the cover back on until it clicks into place.

4 Place the handsets in the base/charger handset cradle andmecharge for 15 hours before use.

5 Plug the telephone line cord into the wall socket.

Attaching the belt clip

With the back of the handset facing you, align the belt clip with the two slots on the side of the handset and push securely into place.

Your Oricom Touch TAM phone is now ready for use.

ATTENTION

Congratulations on your purchase of the Oricom Touch Phone with its high tech touch sensitive keypad. The touch panel is much more sensitive than a normal phone keypad and provides very fast and responsive keying - however like most new technology it takes a little getting used to.

To get the best use out of your Touch Phone

Pick it up from the rear and cradle it in your hand.

During use, avoid touching the keypad area unnecessarily to prevent accidental triggering of the keypad.

The keypad will automatically disable when you hold the receiver to your ear. The idea being, to reduce the risk of accidental keypad presses while the phone is held against the side of your face.

DO YOU HAVE BROADBAND?

If you do you must connect a in-line filter (not supplied) between the telephone socket and your Touch phone base to ensure that your broadband and Touch phone work properly. See below.

IMPORTANT NOTE: Ensure all phone sockets in use have their own in-line filter.

Touch Phone

Telephone socket

In-line filter (not supplied)

Image 4
Contents User Guide Page Pack Contents Environment and Safety Quick SET UP Make sure your base isYour Handset Display Using Your Touch Phone Your Touch Base & Answering Machine Contents To return to standby mode at any time, press Using Your PhoneTouch Activated Keypad Headset connection port Redial a numberPhonebook Store a phonebook entryMenus and Settings Display SettingsHandset settings Navigating the menusReset to Default Settings Recall timeSmart key lock On/Off Manual key lock On/OffClock Settings Setting Caller ID Display FormatSwitching the answer machine on/off Answering machine menu structureVolume Control Answering machine day and timeMailboxes Call ScreeningOutgoing message OGM Answering machine menu optionsRemote Access Security PIN codeNetwork Services Remote operation command tableCaller ID Call logMULTI-HANDSET USE Voice Message/Message WaitingTo clear the icon manually Register a new handsetSimple Solutions TroubleshootingGeneral Information Cleaning your Oricom Touch Phone REN RN for New ZealandWarranty Customer Support