| The Answering Machine |
Appendix |
|
REMOTE ACCESS COMMANDS |
|
Table 1: Commands at the remote menu | Table 2: Commands during message playback |
Key Function
2To play messages
4To play Memo
5To stop an operation
6To play OGM
7To record Memo
8To switch the answering machine on/off
9To record OGM
0 Press twice to delete all old messages
Key | Function |
1 | To play previous message |
2 | To repeat current message |
3 | To play next message |
5 | To stop message playback |
0 | To delete current message |
Troubleshooting
Problem(s)
No dial tone
Signal icon flashing
Registration fails continuously
No parking tone
Handset on the charger does not charge
No display
Bad audio (crackles, echo, etc.)
Handset does not ring
Caller ID does not display number
Cannot make/answer a 2nd call
Tip(s)
•Check your phone connections.
•The handset may be out of range. Move closer to the base.
•The battery capacity may be low. Charge battery.
•The handset may be out of range. Move closer to the base.
•If the handset displays UNREGISTERED, register the handset. See page 20.
•Your base memory may be full. Delete any
•The handset may not be placed properly on the cradle. Try again.
•Charging contacts may be dirty. Disconnect the power supply first and then clean contacts with a damp cloth.
•Turn on the handset tone. See page 18.
•The batteries may be defective. Purchase new batteries from your dealer.
•Check that the batteries are inserted correctly.
•Make sure the handset is placed properly on the charger. The battery icon animates while charging.
•Check that the batteries are charged.
•Check the power and phone connections.
•If you have Broadband installed you MUST install high quality line filters (not supplied) on all phone sockets. This is not a problem with your phone.
•The handset may be nearly out of range. Move closer to the base unit.
•The phone may be interfered by nearby electrical appliances. Move the base unit.
•The phone may be at a location with thick walls. Move the base unit.
•Check that the handset ringer is turned on. See page 18.
•Caller ID service may not be activated. Check with your service provider.
•The caller’s information may be withheld or is unavailable.
•2nd call service may not be activated. Check with your service provider.
•Check that the recall selection is correct. See page 19.
•Check that the correct country has been selected. See page 9.
27