Oricom ECO600 manual Getting Started, Connecting Your Charger

Call

Getting Started

CONNECTING YOUR PHONE

1.Connect the output plug of the mains adaptor to the bottom of the base unit.

2.Connect the mains adaptor to a standard wall outlet.

3.Connect the telephone line cord to the phone socket at the bottom of

the base unit and the wall phone socket.

Note: In Australia some phone wall sockets are the old “non modular” style. If you have this type of wall socket you will need to purchase a modular converter plug (not supplied).These can be obtained from electronic stores.

IMPORTANT NOTE: DO YOU HAVE BROADBAND? If you do you must connect an in-line filter (not supplied) between the telephone socket and your ECO600 phone base to ensure that your broadband and phone work properly. Ensure all phone sockets in use have their own in-line filter.

CONNECTING YOUR CHARGER

*For multi-pack customer only

1.Connect the power adaptor of the charger to a standard wall outlet.

CHARGING YOUR HANDSET

WARNING: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. Never use non-rechargeable batteries. Use recommended type supplied with this product. Ni-MH batteries must be disposed of in accordance with the applicable waste disposal regulations.

NOTE: Charge the handset(s) for 14 hours before initial use!

CAUTION: Check the batteries polarity when inserting the batteries. Incorrect polarity maydamage the product.

1.Place the 2 rechargeable batteries (included) into the battery compartment.

2.Slide the battery door firmly into place.

8