RCA 16211370 manual Other Information, Display Messages, Troubleshooting Guide

Page 29

Other Information

Display Messages

The following special messages indicate the status of a message or the unit:

NO CALLS						The CID memory log is empty.
UNKNOWN CALLER						The incoming call does not have CID service or their service area is
						not linked to yours. If UNKNOWN CALLER appears along with a
						calling number, the name information for that number was not
						available.
BLOCKED CALL						The caller is registered as “Private Number” and their CID
						information is withheld.
INCOMPLETE DATA						Caller information has been interrupted or corrupted during
						transmission.
NO DATA						No CID signal has been detected, or CID service has not been
						activated.
START/END						You are at the beginning or the end of the CID memory log.
						Battery power level is low or battery is not installed.
						Battery power level is low or battery is not installed.

Troubleshooting Guide

No dial tone

•Check or repeat installation steps:

Make sure the telephone line cords are connected to the phone and the wall jack . Make sure the cords are not damaged .

•Make sure the hook switch pop s up when the handset is lifted .

•Check the SPEAKER button. Is the indicator off?

•Disconnect the phone from the wall jack and connect another phone to the same jack. If there is no dial tone in the second phone, the problem might be your wiring or local service.

29

Image 29

Contents Model Interference Information Important InformationEquipment Approval Information Table of Contents Memory Accessory Order Form Introduction Base Layout Connections and SetupParts Checklist InstallationImportant Installation Information Wall plateTelephone Jack RequirementsInstalling the Phone Connections and Setup Data Port Display Language Manually Setting the Date and TimeProgramming the Telephone Hour Format Flash TimeLocal Area Code Call Alert ToneDisplay Contrast Regional Area CodesRestoring the Defaults Voice Mail Access CodesTelephone Operation Telephone OperationMaking Calls with the Handset Making Calls with the SpeakerphoneReceiving Calls with the Handset Switching Between the Speakerphone, Handset, and HeadsetReceiving Calls with the Speakerphone Receiving Calls with the Optional HeadsetMute Call TimerPre-Dialing Telephone Numbers Hold VolumeFlash RedialDo Not Disturb ConferenceVoice Messaging Caller ID CID Caller IDSummary Screen Receiving and Storing CID RecordsSaving CID Records to Memory/Phone Directory Memory Reviewing CID RecordsDeleting a CID Record Deleting All CID RecordsCall Waiting Caller ID Memory Direct Access Memory & Directory MemoryStoring a Name and Number in Memory Reviewing Stored Names & NumbersStoring the Last Number Dialed Changing a Stored Name or NumberStoring a Pause Storing a FlashChain Dialing Dialing a Stored NumberDeleting All Directory Memory Display Messages Troubleshooting GuideOther Information See solutions for No dial tone Phone does not ring General Product Care Service For how long after your purchase Limited WarrantyIf you purchased your product outside the USA Index Service Receiving Calls with To Order Accessory Order FormAtlinks USA, Inc