Radio Shack ET-1104 owner manual Paging, Memory Dialing, Storing a Number in Memory

43-1104.fm Page 15 Wednesday, August 18, 1999 8:05 AM

PAGING

To page the person who has the hand- set or to locate the handset when the phone is not in use, press PAGE on the base. The handset beeps for about 15 seconds. To stop the beeping sooner, press TALK on the handset twice or PAGE on the base.

Notes:

•Make sure you press TALK twice to stop the handset from beeping. If you press TALK only once, you get a dial tone.

•If you receive a call while the page is sounding, the handset stops beeping and starts ringing.

MEMORY DIALING

The ET-1104 can store four telephone numbers in speed dial memory, and you can dial these numbers by pressing a single button. You can also store up to 20 more numbers that you can dial by entering a two-digit memory location number.

Storing a Number in Memory

Note: An error tone sounds and the phone exits the storing process if you wait more than 30 seconds between each key press.

1.Lift the handset.

2.Press MEM. The TALK/MUTE LOW BATT indicator blinks.

3.Enter the number and any tone mode changes or pause entries (see “Entering a Pause” on Page 16).

Notes:

Each number you store can be up to 16 digits long.

If you try to enter more than 16 dig- its, the phone sounds an error tone and exits the storing process. Start over at Step 2.

Each tone or pause entry uses one digit of memory.

15