Radio Shack ET-1104 owner manual On a Wall Plate

Page 7

43-1104.fm Page 7 Wednesday, August 18, 1999 8:05 AM

4.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back of the base.

Tabs

Lower

Tab

Slots

5.Route the adapter’s cord through the strain relief slot on the bracket.

Strain

Relief Slot

6.Plug the adapter into a standard AC outlet.

7.Lift the base’s antenna to a vertical position.

On a Wall Plate

1.Insert the bracket’s tabs into the base’s lower tab slots, then press down on the bracket’s clips and in- sert them into the clip slots.

Clip Slots

2.Plug one end of the supplied short modular cord into the TEL LINE jack on the back of the base.

3.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back of the base.

4.Route the adapter’s cord through the narrow groove on the bottom of the bracket.

Narrow

Groove

7

Image 7
Contents ET-1104 Features Fm Page 3 Wednesday, August 18, 1999 805 AM FCC Statement Read this Before InstallationContents Mounting the Phone InstallationOn a Desk Top On a Wall Plate Directly on the Wall Wide Groove Connecting and Charging the Battery Pack Setting the Dialing Mode Setting the RINGER’S Tone and Volume Making and Receiving Calls Setting the Handset VolumeUsing Redial OperationUsing Flash Using MuteMemory Dialing PagingStoring a Number in Memory Dialing a Memory Number Entering a PauseChain-Dialing Service Numbers Using a HeadsetTesting Stored Emergency Numbers Troubleshooting Fm Page 19 Wednesday, August 18, 1999 805 AM Care and Maintenance Replacing Battery Pack Lightning FCC Wants YOU to KnowFm Page 23 Wednesday, August 18, 1999 805 AM RadioShack Division of Tandy Corporation Fort Worth, Texas