Setting the Dialing Mode

43-1101.fm Page 10 Friday, July 9, 1999 9:32 AM

SETTING THE KEYPAD’S RINGER VOLUME

You can adjust the keypad’s ringer vol- ume by repeatedly pressing RINGER AD- JUST when the phone is not in use. The keypad rings with the current volume (high, medium, or low) as you select it.

Note: You cannot adjust the base’s ringer volume.

2.Press TALK so the IN USE indicator lights and listen for a dial tone.

IN USE

Indicator

RINGER

ADJUST

Set TONE-PULSEon the side of the base for the type of service you have. If you are not sure which type you have, do this sim- ple test after charging the battery pack.

1.Set TONE-PULSE to TONE.

3.Press any number other than 0.

Note: If your phone system requires that you dial an access code (9, for example) before you dial an outside number, do not press the access code either.

If the dial tone stops, you have touch- tone service. If the dial tone contin- ues, you have pulse service.

4.If you have tone service, leave TONE- PULSE set to TONE. If you have pulse service, set TONE-PULSEto PULSE.

5.To hang up, place the keypad on the base or press TALK.