Radio Shack 43-3856 owner manual CONNECTING, Charging and Replacing the Battery Pack

Page 9

5.For a wall plate, plug the modular cord’s other end into the wall plate jack, then align the base’s keyhole slots with the wall plate studs and slide the base downward to secure it.

For direct wall mounting, align the base’s keyhole slots with the mounting screws and slide the base downward to secure it.

6.Plug the adapter into a standard AC outlet.

7.Press and lift out the handset

holder, ﬂip it over as shown, then snap it back into place so it holds the handset.

8.Lift the base’s antenna to a vertical position.

CONNECTING, CHARGING AND REPLACING THE BATTERY PACK

The phone comes with a rechargeable Ni-Cd (nickel-cadmium) battery pack installed in the handset, but not connected. Before using your phone, you must connect the battery pack, then charge it for about 24 hours.

1.Press down and slide off the battery pack compartment cover.

2.Lift the battery pack out of the compartment.

Installation

9

Image 9

Contents With Answering Machine 4GHz Cordless PhoneContents Important Safety InstructionsContents Battery Safety Instructions Introduction Read this Before InstallationIntroduction Installation On a Desk TopMounting the Phone On a Wall Plate or Wall CONNECTING, Charging and Replacing the Battery Pack Installation Recycling Ni-Cd Batteries Depending on your dialing system, set the mode as followsMaking and Receiving Calls OperationEarpiece Volume Handset Ringer ToneTemporarily Mute Ringer Traveling OUT-OF-RANGE Selecting a Different ChannelFlash and Call Waiting Storing Phone Numbers in Memory Memory DialingMaking Calls with Memory Dialing Chain DialingErasing a Stored Number from Memory Testing Stored Emergency NumbersONE-TOUCH Speed Dial Storing the Speed Dial ÔIntegrated Answering Device Making Calls with the Speed DialDeleting the Speed Dial Turning the Answering System FeaturesSetting UP Your Answering System Using the Menu ModeSetting the Time Setting the Ring Time Setting a Personal Security Code PINSelecting the message Record Time Announce only featureSetting the Message Alert tone Selecting the Language Preset message Setting Your Outgoing Message GreetingRecording a personal outgoing message Greeting Ô Choosing between the two outgoing messagesSetting the base ringer volume Adjusting the speaker volume levelTemporarily Mute the Base Ringer Using Your Answering System Playing your messagesRepeating a message Deleting a message Skipping a messageRecording a conversation Voice memoCommand Function Remote access away from homeTurn on the answering system remotely Headset Installation Installing the Optional BeltclipAdditional Information To attach the beltclipProblem Solution TroubleshootingIncoming messages may be too long. Remind callers to FCC Statement CareFCC Statement Surge ProtectionPage Page Page Limited One-Year Warranty