Radio Shack 43-3856 owner manual Surge Protection, FCC Statement

Page 36

FCC Statement

Ô NOTE Ô

Some cordless telephones operate on frequencies that might cause interference to nearby TVs and VCRs. To minimize or prevent such interference, the base of the cordless telephone should not be placed near or on top of a TV or VCR.

We have designed your phone to conform to federal regulations, and you can connect it to most telephone lines. However, each phone (and each device, such as a telephone or answering machine) that you connect to the telephone line draws power from the telephone line. We refer to this power draw as the device’s ringer equivalence number, or REN on the back of your phone.

If you use more than one phone or other device on the line, add up all of the RENs. If the total is more than five (three in rural areas), your telephones might not ring. If ringer operation is impaired, remove a device from the line.

In the unlikely event that your phone causes problems on the phone line, the phone company can temporarily discontinue your service. If this happens, the phone company attempts to notify you in advance. If advance notice is not practical, the phone company notifies you as soon as possible and advises you of your right to file a complaint with the FCC.

Also, the phone company can make changes to its lines, equipment, operations, or procedures that could affect the operation of this phone. The telephone company notifies you of these changes in advance, so you can take the necessary steps to prevent interruption of your telephone service. Ô

SURGE PROTECTION

Your telephone has built-in protection circuits to reduce the risk of damage from surges in telephone line and power line current. These protection circuits meet or exceed the FCC requirements. However, lightning striking the telephone or power lines can damage your telephone.

Lightning damage is not common. Nevertheless, if you live in an area that has severe electrical storms, we suggest that you unplug your phone when storms approach to reduce the possibility of damage.

36

Image 36
Contents 4GHz Cordless Phone With Answering MachineImportant Safety Instructions ContentsContents Battery Safety Instructions Read this Before Installation IntroductionIntroduction Installation On a Desk TopMounting the Phone On a Wall Plate or Wall CONNECTING, Charging and Replacing the Battery Pack Installation Depending on your dialing system, set the mode as follows Recycling Ni-Cd BatteriesOperation Making and Receiving CallsEarpiece Volume Handset Ringer ToneTemporarily Mute Ringer Traveling OUT-OF-RANGE Selecting a Different ChannelFlash and Call Waiting Memory Dialing Storing Phone Numbers in MemoryMaking Calls with Memory Dialing Chain DialingTesting Stored Emergency Numbers Erasing a Stored Number from MemoryONE-TOUCH Speed Dial Storing the Speed Dial ÔIntegrated Answering Device Making Calls with the Speed DialDeleting the Speed Dial Features Turning the Answering SystemUsing the Menu Mode Setting UP Your Answering SystemSetting the Time Setting a Personal Security Code PIN Setting the Ring TimeAnnounce only feature Selecting the message Record TimeSetting the Message Alert tone Selecting the Language Setting Your Outgoing Message Greeting Preset messageRecording a personal outgoing message Greeting Ô Choosing between the two outgoing messagesSetting the base ringer volume Adjusting the speaker volume levelTemporarily Mute the Base Ringer Using Your Answering System Playing your messagesRepeating a message Skipping a message Deleting a messageVoice memo Recording a conversationRemote access away from home Command FunctionTurn on the answering system remotely Installing the Optional Beltclip Headset InstallationAdditional Information To attach the beltclipTroubleshooting Problem SolutionIncoming messages may be too long. Remind callers to Care FCC StatementSurge Protection FCC StatementPage Page Page Limited One-Year Warranty