Radio Shack TAD 1130 owner manual Quick Look AT the Handset, Setting the Dialing Mode

Page 12
PULSE-TONE

43-1130.fm Page 12 Tuesday, May 30, 2000 1:22 PM

A QUICK LOOK AT THE HANDSET

Note: The handset window has plastic film on it to protect it during shipment. Carefully peel off the film before using your phone for the first time.

Use MEMORY to store and dial names and numbers in memory (see “Memory Dialing” on Page 15).

Use TALK to make a call (see “Making and Receiving Calls with the Handset” on Page 14).

Use REDIAL to redial the last number dialed (see “Using Redial” on Page 15).

Use PAUSE to store a pause in a number (see “Entering a Pause” on Page 16).

Use VOL 8/9 to adjust the handset volume (see “Adjusting the Handset Volume” on Page 14).

Use MUTE talk to some in the room without the person on the other end of the phone line hearing your conversation (see “Using Mute” on Page 15

Use FLASH to select the phone’s flash function (see “Using Flash” on Page 15).

Use CHANNEL to select the phone’s channels (see “Se- lecting the Channel” on Page 14) and other options.

Press TONE to use your phone company’s special tone services when you are on a pulse line (see “Using Tone Services on a Pulse Line” on Page 15).

SETTING THE DIALING MODE

Set PULSE-TONEon the back of the base for the type of service you have. If you are not sure which type you have, after you charge the handset battery pack, do this simple test.

1.Set PULSE-TONE to TONE.

2.Lift the handset, press TALK and listen for a dial tone.

3.Press any number other than 0.

Note: If your phone system requires that you dial an access code (9, for example) before you dial an outside number, do not press the access code number either.

If the dial tone stops, you have touch-

tone service. Leaveset to TONE.

If the dial tone continues, you have pulse service. Set PULSE-TONEto

PULSE.

12

 

Installation

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Image 12
Contents TAD GHz Digital Spread Spectrum Cordless Speakerphone Contents Important Safety Instructions TroubleshootingFm Page 4 Tuesday, May 30, 2000 122 PM Battery Safety Instructions Save These Instructions Read this Before InstallationFCC Statement Features FCC Wants YOU to KnowLightning Telephone Features Answering System FeaturesInstallation Mounting the PhoneOn a Desk Top On a Wall Plate or Wall CONNECTING, CHARGING, and Replacing the Battery Pack Installation Setting the Dialing Mode Quick Look AT the HandsetSetting the Ringer TONE/VOLUME Setting the Number of RingsSetting the DAY/TIME Turning the BASE’S Ringer on and OFFTelephone Operation Using Flash Using RedialUsing Mute Using Tone Services on a Pulse LineUsing a Headset Chain-Dialing Service NumbersTesting Stored Emergency Num- bers Entering a PauseSetting the Record Time TAD OperationSelecting the Outgoing Message RECORDING/DELETING AN Outgoing MessageSetting the TAD to Answer Calls Screening CallsRecording a Memo Recording Incoming MessagesAdjusting the TAD’S Volume Setting the Remote Operation PINPlaying Messages Deleting MessagesUsing the TOLL-SAVER Using Remote CommandsRemote Operation Remote Commands Press # ThenTroubleshooting Problem SuggestionCare Limited One-Year Warranty