Radio Shack TAD 1130 owner manual Installation, Mounting the Phone, On a Desk Top

Page 8
DC IN 9V

43-1130.fm Page 8 Tuesday, May 30, 2000 1:22 PM

ˆInstallation

MOUNTING THE PHONE

You can place the TAD’s base on a desk or table, or mount it on a standard wall plate or directly on a wall.

Choose a location that is:

near an AC outlet

near a modular telephone line jack

out of the way of normal activities

away from electrical machinery, electri- cal appliances, metal walls or filing cabi- nets, wireless intercoms, alarms, and room monitors

away from other cordless phones

The base’s location affects the phone’s range. If you have a choice of several loca- tions, try each to see which provides the best performance.

Cautions:

You must use a Class 2 power

!source that supplies 9V DC

and delivers at least 350 mA. Its center tip must be set to positive and its plug must fit the telephone's

jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the telephone or the adapter.

Always connect the AC adapter to the phone before you connect it to AC power. If you disconnect the power, dis- connect the adapter from AC power before you disconnect it from the phone.

Notes:

Your telephone connects directly to a modular telephone line jack. If your phone line jack is not a modular jack, you can update the wiring yourself, using jacks and adapters available at your local RadioShack store. Or, you can let the phone company update the wiring for you.

The USOC number of the jack to be installed is RJ11C (RJ11W for a wall plate).

On a Desk Top

1.Insert the bracket’s tabs into the base’s upper tab slots, then press down on the bracket’s clips and insert them into the clip slots.

2.Plug one end of the supplied long modu- lar cord into the TEL LINE jack on the back of the base.

3.Plug the modular cord’s other end into a modular telephone line jack.

4.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back of the base.

5.Route the adapter’s cord through the strain relief slot on the bracket.

6.Plug the adapter into a standard AC out- let.

8

 

Installation

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Image 8
Contents TAD GHz Digital Spread Spectrum Cordless Speakerphone Contents Important Safety Instructions TroubleshootingFm Page 4 Tuesday, May 30, 2000 122 PM FCC Statement Battery Safety InstructionsSave These Instructions Read this Before Installation Lightning FeaturesFCC Wants YOU to Know Telephone Features Answering System FeaturesOn a Desk Top InstallationMounting the Phone On a Wall Plate or Wall CONNECTING, CHARGING, and Replacing the Battery Pack Installation Setting the Dialing Mode Quick Look AT the HandsetSetting the Ringer TONE/VOLUME Setting the Number of RingsSetting the DAY/TIME Turning the BASE’S Ringer on and OFFTelephone Operation Using Flash Using RedialUsing Mute Using Tone Services on a Pulse LineUsing a Headset Chain-Dialing Service NumbersTesting Stored Emergency Num- bers Entering a PauseSetting the Record Time TAD OperationSelecting the Outgoing Message RECORDING/DELETING AN Outgoing MessageSetting the TAD to Answer Calls Screening CallsRecording a Memo Recording Incoming MessagesAdjusting the TAD’S Volume Setting the Remote Operation PINPlaying Messages Deleting MessagesRemote Operation Using the TOLL-SAVERUsing Remote Commands Remote Commands Press # ThenTroubleshooting Problem SuggestionCare Limited One-Year Warranty