Radio Shack TAD 1130 owner manual Telephone Operation

Page 14

43-1130.fm Page 14 Tuesday, May 30, 2000 1:22 PM

ˆTelephone Operation

MAKING AND RECEIVING CALLS WITH THE HANDSET

To make a call, lift the handset and press TALK. The TALK/LOW BATT indicator on the handset and the CHARGE/IN USE indicator on the base light. Dial the number.

To answer a call, lift the handset from the base or, if the handset is away from base, press any key to make or answer a call.

To end a call, place the handset on the base or press TALK.

ANSWERING CALLS WITH THE SPEAKERPHONE

To answer a call using the speakerphone, press SPEAKER. The SPEAKER indicator lights.

To adjust the speakerphone’s volume, re- peatedly press VOLUME 8 or 9 on the base. The volume setting from 1 (lowest) to 10 (highest) appears in the message counter window.

To end a speakerphone call, press SPEAKER again.

ADJUSTING THE HANDSET VOLUME

To adjust the volume you hear through the handset during a call, press VOL 8 or 9#to increase or to decrease the volume.

Note: If you press VOL 8 or 9 while the volume is set to the maximum or lowest lev- el, the setting does not change and you hear three quick beeps.

SELECTING THE CHANNEL

The phone scans 30 channels (frequency pairs used between the base and the hand- set) and automatically selects a clear chan- nel each time you make or receive a call.

If you hear other conversations or excessive noise during a call, press CHANNEL to select a different channel.

Note: If the handset is too far from the base, the channel might not change. Move closer to the base and try again.

SWITCHING BETWEEN THE HANDSET AND SPEAKERPHONE

To switch to the speakerphone while you are using the handset, press SPEAKER on the base. When you hear the conversation on the speakerphone, press TALK on the hand- set.

To switch to the handset while you are using the speakerphone, lift the handset off the base. If the handset is away from the base, press TALK, then press SPEAKER.

USING BOTH THE HANDSET AND SPEAKERPHONE

If someone else is using the speakerphone, press TALK on the handset to join the con- versation. If someone else is using the hand- set, press SPEAKER on the base to join the conversation.

During the call, one person can hang up and let the call continue at the other keypad. Or, both people can hang up to end the call.

14

Telephone Operation

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Image 14
Contents TAD GHz Digital Spread Spectrum Cordless Speakerphone Contents Important Safety Instructions TroubleshootingFm Page 4 Tuesday, May 30, 2000 122 PM FCC Statement Battery Safety InstructionsSave These Instructions Read this Before Installation Lightning FeaturesFCC Wants YOU to Know Telephone Features Answering System FeaturesOn a Desk Top InstallationMounting the Phone On a Wall Plate or Wall CONNECTING, CHARGING, and Replacing the Battery Pack Installation Setting the Dialing Mode Quick Look AT the HandsetSetting the DAY/TIME Setting the Ringer TONE/VOLUMESetting the Number of Rings Turning the BASE’S Ringer on and OFFTelephone Operation Using Mute Using FlashUsing Redial Using Tone Services on a Pulse LineTesting Stored Emergency Num- bers Using a HeadsetChain-Dialing Service Numbers Entering a PauseSelecting the Outgoing Message Setting the Record TimeTAD Operation RECORDING/DELETING AN Outgoing MessageRecording a Memo Setting the TAD to Answer CallsScreening Calls Recording Incoming MessagesPlaying Messages Adjusting the TAD’S VolumeSetting the Remote Operation PIN Deleting MessagesRemote Operation Using the TOLL-SAVERUsing Remote Commands Remote Commands Press # ThenTroubleshooting Problem SuggestionCare Limited One-Year Warranty