Radio Shack ET-925 owner manual Entering a Pause

43-1095.fm Page 18 Tuesday, August 17, 1999 3:37 PM

1.Press MEM on the handset or the base. The TALK/BATT LOW or IN USE indicator blinks.

Note: If you hear a dial tone when you pick up the handset, press TALK to turn it off before pressing

MEM.

2.Enter the number (up to 16 digits) and any TONE/ mode changes or pause entries (see “Using Tone Services on a Pulse Line” on Page 16 or “Entering a Pause”).

Notes:

•Each TONE/ or pause entry uses one digit of memory.

•If you try to enter more than 16 digits, the phone beeps 5 times and exits the programming mode. Start over at Step 1.

3.Press MEM again, then enter the memory location number (0–9) where you want to store the num- ber. A tone sounds to indicate that the number is stored.

4.For each stored number, write the person’s or company’s name next to the appropriate location number on the supplied MEMORY directo- ry sticker. (Use a pencil in case you need to change the number

18

later.) Then attach the sticker to the phone.

To clear a stored number, simply store a new number in its place. Or, press MEM twice. Then press the memory lo- cation number (0–9) you want to clear. A tone sounds.

Note: If you hear a dial tone when you pick up the handset, press TALK to turn it off before pressing MEM twice.

Entering a Pause

In some telephone systems, you must dial an access code (9, for example) and wait for a second dial tone before you can dial an outside number. You can store the access code with the phone number. However, you must also store a pause after the access code to allow the outside line time to connect. To enter a 2-second pause, press REDIAL/P (or REDIAL on the base). For a longer pause, press REDI- AL/P (or REDIAL on the base) addition- al times.