Memory Dialing
Ô NOTE Ô
•Each tone or pause entry uses one digit of memory.
•If you press END or do not press a key for 30 seconds, the phone exits the phonebook store mode.
•When the memory is full,
a beep sounds and
Memory Full
appears. You cannot store the names and numbers.
•If you select a speed dial location where a number is already stored, the new number replaces the old number, and the old number is stored as a normal memory number.
6.To enter a number, repeatedly press the corresponding number key until the number appears.
7.To enter a special character, press 0 repeatedly
to select one of the following characters:
∗ # - & ( ) (space) 0
8.If you make a mistake, press ê/SPEED DIAL/% to move the cursor back to the incorrect entry, press DEL/TRSF to delete the wrong character. Then enter the correct character.
9.Press SEL/CH. Store/Edit No. appears.
10.Enter the number and any tone or pause entries (see “Using Tone Services on a Pulse Line” on Page 17 and “Entering a Pause” on Page 21). Ô
11.Press SEL/CH. Distinctive Ring appears.
12.Press # or ∃ to select the ringer, or No Selectn if you do not want to assign a distinctive ring.
Each time you make a selection, the selected ringer or the melody sounds (unless you selected No Selectn). See “Turning the Distinctive Ringer On/Off” on Page 23.
13.Press SEL/CH. Speed Dial appears.
If the selected location has no number, SPDn: and <Empty> appear. The name that is stored in that location also appears. If you are editing a number already stored in a speed dial location, the pointer moves to the location where <Current> appears.
Press ∃ to select a speed dial location (SPD1– SPD0) or No selectn if you do not want to store in the selected speed dial location.
14.Press SEL/CH. Done! appears. Ô
20