Radio Shack 2-Line 900 MHz Handsfree Cordless Phone owner manual Recharging the Battery Pack

Page 11

43-1701.fm Page 11 Wednesday, September 20, 2000 8:48 AM

phone. Otherwise, the battery pack loses its ability to fully recharge.

If the front CHARGE indicator does not light when you place the keypad on the base, be sure the battery pack and AC adapter are correctly and securely connected. Also, check the charging contacts on the keypad and base. If the contacts are dirty or tarnished, clean them with a pencil eraser.

If the battery pack becomes completely discharged or the base loses power while the keypad is away from it, place the keypad on the base for about 5 seconds to reset the security access protection code. If the keypad loses power, leave it on the base to charge the battery pack.

If you are not going to use your phone for an extended period of time, disconnect its battery pack. This helps increase the battery pack’s usable life.

Recharging the Battery Pack

The battery pack should last about a year. If the battery pack does not hold a charge for more than 2 hours after an overnight charge, replace it. You can order a replacement battery pack through your local RadioShack store.

Note: To avoid losing numbers stored in memory, you must in- stall and begin charging the new battery pack within 2 minutes of removing the old one.

1.To remove the old battery pack, press the latch release, then slide the battery pack off the keypad.

Preparation

11

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Image 11
Contents Line 900 MHz Handsfree Cordless Phone Contents Fm Page 3 Wednesday, September 20, 2000 848 AM FCC Statement Read this Before InstallationFm Page 5 Wednesday, September 20, 2000 848 AM Ring/Vibrate Dual Mode Selection lets you set the ringer to FeaturesSelecting a Location Quick Look at the PhonePreparation Preparation Connecting the BaseConnecting and Charging the Battery Pack Pack, place the keypad Recharging the Battery Pack Fm Page 12 Wednesday, September 20, 2000 848 AM Connecting and Adjusting the Headset Turning the Ringers on or OFF Setting RING/VIBRATE/DUALSetting the Dialing Mode Operation Adjusting the HEADSET’S Volume Using Conference Using HoldChanging Channels Using RedialUsing Mute Using Using FlashUsing Tone Services on a Pulse Line Storing a Number in Memory Memory DialingDialing a Stored Number Chain-Dialing Service NumbersEntering a Pause in Memory Number Testing Stored Emergency Numbers TroubleshootingLightning Troubleshooting2343-1701 RadioShack Corporation 08A00 Fort Worth, Texas