Radio Shack 2-Line 900 MHz Handsfree Cordless Phone owner manual

Page 12

43-1701.fm Page 12 Wednesday, September 20, 2000 8:48 AM

2.To connect the new battery pack, line up the slots on the battery pack with the posts on the keypad, then press down and slide it forward until the latch clicks.

3.Charge the battery pack for 12 hours before using it.

Cautions:

Be careful not to short the battery pack by touching it with conducting materials, such as rings, bracelets, and keys. The battery pack or conductor might overheat and burn.

Do not dispose of the battery pack in a fire because it might explode.

Do not open or mutilate the battery pack.

Note: If you have trouble replacing the battery pack, take the phone to your local RadioShack store for assistance.

Important: The EPA certified RBRC® Battery Re- cycling Seal on the nickel-cadmium (Ni-Cd) bat- tery indicates RadioShack is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful

life, when taken out of service in the United States or Canada. The RBRC program provides a convenient alternative to placing used Ni-Cd batteries into the trash or the municipal waste stream, which may be illegal in your area. Please call 1-800- THE-SHACK (1-800-843-7422) for information on Ni-Cd battery recycling and disposal bans/restrictions in your area. RadioShack’s involvement in this program is part of the compa- ny’s commitment to preserving our environment and conserving our natural resources.

12

 

Preparation

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Image 12
Contents Line 900 MHz Handsfree Cordless Phone Contents Fm Page 3 Wednesday, September 20, 2000 848 AM Read this Before Installation FCC StatementFm Page 5 Wednesday, September 20, 2000 848 AM Features Ring/Vibrate Dual Mode Selection lets you set the ringer toQuick Look at the Phone PreparationSelecting a Location Connecting the Base PreparationConnecting and Charging the Battery Pack Pack, place the keypad Recharging the Battery Pack Fm Page 12 Wednesday, September 20, 2000 848 AM Connecting and Adjusting the Headset Setting RING/VIBRATE/DUAL Setting the Dialing ModeTurning the Ringers on or OFF Operation Adjusting the HEADSET’S Volume Using Hold Using ConferenceUsing Redial Using MuteChanging Channels Using Flash Using Tone Services on a Pulse LineUsing Memory Dialing Storing a Number in MemoryChain-Dialing Service Numbers Entering a Pause in Memory NumberDialing a Stored Number Troubleshooting Testing Stored Emergency NumbersTroubleshooting23 Lightning43-1701 RadioShack Corporation 08A00 Fort Worth, Texas