Radio Shack 2-Line 900 MHz Handsfree Cordless Phone Connecting and Charging the Battery Pack

Page 9

43-1701.fm Page 9 Wednesday, September 20, 2000 8:48 AM

Cautions:

You must use a Class 2 power source that supplies

!15V DC and delivers at least 300 mA. Its center tip must be set to positive and its plug must fit the

phone's 15V 300 mA jack. Using an adapter that does not meet these specifications could damage the phone or the adapter.

•Always connect the AC adapter to the phone before you con- nect it to AC power. When you finish, disconnect the adapter from AC power before you disconnect it from the phone.

1.If you have a RJ14C modular telephone line jack for 2 line usage, plug one end of the supplied 4-pin modular cord into TEL LINE 1/2. Then plug the other end into the RJ14C mod- ular phone line jack.

If you have two RJ11C modular telephone line jacks for using 2 lines, plug one end of the supplied 4–pin modular cord into TEL LINE 1/2, and one end of the supplied 2–pin modular cord into TEL LINE 2. Then plug the modular cords’ other ends into the RJ11C modular phone line jacks.

2.Lift the base’s antenna to a vertical position.

CONNECTING AND CHARGING THE BATTERY PACK

The phone comes with two rechargeable nickel-cadmium bat- tery packs. You must connect the battery pack and charge it for at least 12 hours for the first time before you use the phone.

Preparation

9

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Line 900 MHz Handsfree Cordless Phone Contents Fm Page 3 Wednesday, September 20, 2000 848 AM FCC Statement Read this Before InstallationFm Page 5 Wednesday, September 20, 2000 848 AM Ring/Vibrate Dual Mode Selection lets you set the ringer to FeaturesQuick Look at the Phone PreparationSelecting a Location Preparation Connecting the BaseConnecting and Charging the Battery Pack Pack, place the keypad Recharging the Battery Pack Fm Page 12 Wednesday, September 20, 2000 848 AM Connecting and Adjusting the Headset Setting RING/VIBRATE/DUAL Setting the Dialing ModeTurning the Ringers on or OFF Operation Adjusting the HEADSET’S Volume Using Conference Using HoldUsing Redial Using MuteChanging Channels Using Flash Using Tone Services on a Pulse LineUsing Storing a Number in Memory Memory DialingChain-Dialing Service Numbers Entering a Pause in Memory NumberDialing a Stored Number Testing Stored Emergency Numbers TroubleshootingLightning Troubleshooting2343-1701 RadioShack Corporation 08A00 Fort Worth, Texas
Top Page Image Contents