Radio Shack TAD-732 owner manual Using the Handset, Deleting an Outgoing Message

Page 24

43-732.fm Page 24 Friday, August 13, 1999 1:42 PM

If the TAD’s memory is full (FL flash- es) you must delete some messag- es before you can record a new outgoing message.

Using the Handset

1.Press REMOTE. The REMOTE indi- cator lights and ––appears on the base.

5.Press REMOTE. The REMOTE indi- cator turns off.

To play the outgoing message at any time, press REMOTE then ANNC (0) on the handset, or press ANNC on the base.

Note: You can only use the handset to record the outgoing messages and memos. But you can play messages by using the base or handset.

2.Press CHANGE () then ANNC (0). The handset beeps once.

3.Speak your message in a normal voice, as though you were talking to someone on the phone.

4.Press STOP (5) when you finish the message. The TAD plays back the outgoing message, then beeps twice.

24

Deleting an Outgoing Message

To delete your outgoing message and use the prerecorded message, press DELETE then ANNC on the base, or RE-

MOTE, DELETE (9), then ANNC (0) on the

handset.

Image 24
Contents TAD-732 Features TAD FeaturesTelephone Features Read this Before Installation FCC StatementContents Replacing the Battery Pack FCC Wants You to Know Installing the HANDSET’S Antenna PreparationSelecting a Location Installing the Phone Placing the Base on a Desk TopMounting the Base on a Wall Plate Mounting the Base Directly on the Wall 315/16 Connecting and Charging the Handset Battery Pack Fm Page 13 Friday, August 13, 1999 142 PM Setting the Dialing Mode Setting the Number of Rings Setting the DAY and TimeTurning the Ringers OFF or on With the Handset With the BaseSetting the HANDSET’S Volume Telephone OperationMaking and Receiving a Call Changing ChannelUsing Redial Using FlashUsing Mute Using Memory DialingChain-Dialing Service Numbers Storing a Number in Memory Entering a PauseDialing a Stored Number Using AN Optional Headset Testing Stored Emergency NumbersRemoving the Belt Clip Fm Page 22 Friday, August 13, 1999 142 PM Setting the TAD to Answer Calls Using the MailboxesTAD Operation Using the Handset Deleting an Outgoing MessageUsing the ANNOUNCE- only Feature Adjusting the TAD’S VolumeScreening Calls Recording Incoming Messages Recording a MemoPlaying Messages Deleting Messages Changing the Remote Operation Security CodeUsing TOLL-SAVER Using Remote ANSWER-ONUsing Remote Commands Remote OperationRemote Commands Press Record a memo to MailboxTroubleshooting Problem SuggestionCare and Maintenance Replacing Battery Pack FCC Wants YOU to Know LightningFm Page 35 Friday, August 13, 1999 142 PM RadioShack Division of Tandy Corporation Fort Worth, Texas