Radio Shack 900MHz owner manual Care

Page 29

Problem

 

Suggestion

 

 

 

 

 

 

Handset does not ring or

•

Lift the base’s antenna to a vertical position.

receive a page.

• Move the handset closer to the base.

 

 

• Move the handset and base away from other electrical

 

 

devices.

 

• Recharge the battery pack.

 

 

 

The TAD does not answer

•

Make sure the TAD is turned on.

calls.

•

Make sure the AC adapter is properly connected.

 

 

• Check all phone line connections.

 

 

 

The TAD does not record

•

REC TIME is set to ANN (announcement only). Set it to 1

callers’ messages.

 

or 4.

 

• Delete message if memory is full.

 

 

 

E E flashes.

•

Microprocessor failure. Disconnect the AC adapter, wait 15

 

 

seconds, then plug in the adapter again.

 

 

 

If the base loses power while the handset is off of it, the security access-protection code might change. Restore power to the base, then place the handset back on the base and leave it there for a few seconds.

If you still have problems, disconnect the phone. If other phones on the same line work properly, the fault is in this phone or its installation. If you cannot find the prob- lem, take your phone to your local RadioShack store for assistance.

ˆCare

To enjoy your RadioShack 2-Line 900 MHz Cordless Answering System for a long time:

•Keep the telephone dry. If it gets wet, wipe it dry immediately.

•Use and store the telephone only in normal temperature environments.

•Handle the telephone gently and carefully. Do not drop it.

•Keep the telephone away from dust and dirt.

•Wipe the telephone with a damp cloth occasionally to keep it looking new.

Care

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Line 900MHz Cordless Answering Machine Tandy Corporation All Rights Reserved Contents Using the Toll-Saver Using Remote Commands Telephone Features FeaturesTAD Features Important Safety Instructions Read this Before InstallationFeatures Features Mounting the Phone InstallationQuick Look At Your Telephone On a Desk Top Connecting to Phone LinesOn a Wall Plate or a Wall Connecting Charging Battery Pack Adjusting the Ringer Setting the Dialing ModeOn the Handset On the BaseSetting the DAY/TIME Setting the Number of RingsBasic Operation Making a CallAdjusting Speakerphone Volume Setting the Handset VolumeUsing Mute Answering a CallSwitching Between the Handset and Speakerphone Using HoldUsing Both Handset Speakerphone Making a Conference CallUsing Flash Using the Phone with Extension PhonesUsing Redial Using Tone Services on a Pulse Line Storing a Number in Memory Using a HeadsetMemory Operation Testing Stored Emergency Numbers Chain-Dialing Service NumbersDialing a Memory Number Entering a PauseRECORDING/DELETING AN Outgoing Message Setting the Record TimeTAD Operation Recording Incoming Messages Setting the Phone to Answer CallsScreening Calls Playing Messages Recording a MemoRecording a Conversation Deleting Messages Adjusting the TAD’S VolumeRemote Operation Using the TOLL-SAVERUsing Remote Commands Remote Commands Problem Suggestion TroubleshootingCare Important This tele Replacing Battery PackLightning FCC Wants YOU to KnowRadioShack
Top Page Image Contents