Radio Shack 900MHz owner manual Adjusting the TAD’S Volume, Deleting Messages

Page 25

number appears as each message plays, and the phone announces the day and time of the call at the end of each message.

To play all messages after playing the new messages, press PLAY/STOP again. To skip to the next message, press SKIP during playback. If you know the mes- sage number of the one you want to hear, hold down SKIP until the desired number appears.

To replay the current message from the beginning, press REPEAT. If you press REPEAT within about 2 seconds (4 sec- onds during remote operation) after a message begins playing, the phone re- plays the previous message.

If you know the message number of the one you want to hear, hold down RE- PEAT until the desired number appears.

ADJUSTING THE TAD’S VOLUME

To adjust the speaker’s volume, repeat- edly press VOLUME 8 or 9 on the base. The volume setting from 1 (low- est) to 10 (highest) appears in the mes- sage counter window.

DELETING MESSAGES

To delete the current message while it is playing, press DELETE. The phone beeps.

To delete all messages on either line at once, repeatedly press MSG LINE SE- LECT until the line indicator for the de- sired line lights in the message counter window. Then, while messages are not playing, hold down DELETE on the base

until the phone beeps and 0 appears in the message counter window.

Note: You cannot delete new (unplayed) messages. If you try to delete all mes- sages at once while you still have new messages, the phone sounds a long beep and deletes old messages only.

SETTING THE REMOTE OPERATION PIN

The phone’s two-digit remote operation PIN (personal identification number) prevents unauthorized remote access to your messages. The PIN is preset to 80.

Follow these steps to change the PIN to any number from 00 to 99. The PIN is common to both lines.

Note: If you wait more than 2 minutes between each keypress, the phone exits the PIN setting process. Start again at Step 1.

1.Hold down PIN until the phone beeps and 00 appears in the mes- sage counter window.

2.Press SKIP to set the first digit of the PIN higher or REPEAT to set it lower. Then press PIN.

3.Press SKIP or REPEAT to set the second digit of the PIN, then press PIN. The phone announces the new PIN.

4.To check your PIN at any time, press PIN. The PIN appears in the message counter window, and the phone announces it.

TAD Operation

25

Image 25
Contents Line 900MHz Cordless Answering Machine Tandy Corporation All Rights Reserved Contents Using the Toll-Saver Using Remote Commands Telephone Features FeaturesTAD Features Important Safety Instructions Read this Before InstallationFeatures Features Quick Look At Your Telephone InstallationMounting the Phone On a Desk Top Connecting to Phone LinesOn a Wall Plate or a Wall Connecting Charging Battery Pack Adjusting the Ringer Setting the Dialing ModeOn the Handset On the BaseSetting the DAY/TIME Setting the Number of RingsBasic Operation Making a CallAdjusting Speakerphone Volume Setting the Handset VolumeUsing Mute Answering a CallSwitching Between the Handset and Speakerphone Using HoldUsing Both Handset Speakerphone Making a Conference CallUsing Redial Using the Phone with Extension PhonesUsing Flash Using Tone Services on a Pulse Line Memory Operation Using a HeadsetStoring a Number in Memory Testing Stored Emergency Numbers Chain-Dialing Service NumbersDialing a Memory Number Entering a PauseTAD Operation Setting the Record TimeRECORDING/DELETING AN Outgoing Message Screening Calls Setting the Phone to Answer CallsRecording Incoming Messages Recording a Conversation Recording a MemoPlaying Messages Deleting Messages Adjusting the TAD’S VolumeUsing Remote Commands Using the TOLL-SAVERRemote Operation Remote Commands Problem Suggestion TroubleshootingCare Important This tele Replacing Battery PackLightning FCC Wants YOU to KnowRadioShack