Radio Shack 900MHz Dialing a Memory Number, Entering a Pause, Chain-Dialing Service Numbers

4.Press MEM, then enter the memory location number (0–9) where you want to store the number. The tone sounds to indicate that the number is stored.

Note: If the phone sounds five quick beeps, you have made an entry error and the number was not stored. Re-enter the location num- ber correctly.

5.Repeat the steps to enter more numbers.

To replace a stored number, simply store a new one in its place. To erase a number for a memory location, press MEM twice. Then press the memory lo- cation number (0–9) you want to clear. A tone sounds.

Entering a Pause

In some telephone systems, you must dial an access code (9, for example) and wait for a second dial tone before you can dial an outside number. You can store the access code with the phone number. However, you should also store a pause after the access code to allow the outside line time to connect. For each 2-second pause you want to enter, press REDIAL.

DIALING A MEMORY NUMBER

To dial a number stored in the memory, lift the handset from the base and press LINE 1 or LINE 2. Then press MEM and the location number (0–9) by pressing a number key. The phone automatically dials the number.

Chain-Dialing Service Numbers

For quick recall of numbers for special services (such as alternate long dis- tance or bank by phone), store each group of numbers in its own memory lo- cation.

To use the stored special service num- bers, dial the service’s main number first. Then, at the appropriate place in the call, press MEM and the number for the memory location where the addition- al information is stored.

Testing Stored Emergency Numbers

If you store an emergency service’s number (police department, fire depart- ment, ambulance) and you choose to test the stored number, make the test call during the late evening or early morning hours to avoid peak demand periods. Also, remain on the line to ex- plain the reason for your call.

Memory Operation 21